Viewing all customer Discussions for:

23-041 Mirror Wardrobe Door Roller Assembly

I have a Stanley Sliding Mirror closet door which needs replacement of one of the rollers. I don't have a part number but have uploaded photos of the roller and a label from the door which may have the model number of the door on it.

Hi I have an ACME 4013 top braket that has it's guide broken I am looking for an alternative or a used one ? Any idea? I would be interested in 4 or 8 of them!!! I would like to avoid having to change the entire top and bottom assembly just for a small plastic piece broken Thanks for your help S ... (cont.)

Good Afternoon, I'm trying to purchase a roller wheel for my closet sliding glass door. I might also need the rail. I am interested if it is available. Thank You

Hello, I recently had some work done on my house and the demo team tossed the old lower track. I have attached what information I could find, the label from one of the two doors and also a roller at the bottom. Is this enough information to locate a double roller track measuring at least 71" long ... (cont.)

I'm looking for PAT No. 3750337 AOVIE 4011 for my sliding door. I'll send my fotos for whome it may concern.I'm looking forward to your answer.facefullyBernd

Hi, looking for a replacement track for these doors. The current track is bent and was cut too short by contractor. Thanks! Overall track width is about 3 5/8" and 47.5" long. I included the wheel part if that helps to identify the needed track better.

We need to order two a bottom tracks.

Dear Swisco:What Bottom Roller assembly and track do I need? The opening is 58 1/2 inches and the rollers are convex, but worn. The roller assembly is 3 1/8 inches wide by 4 1/2 inches. The screw holes are 3 1/8" on the side of the assembly/ side of door and 2 1/4" ond the width or bottom of the ass ... (cont.)

The rollers of my mirror closet door need to be replaced. The plastic wheel is not longer round all around.

Doors are about 8 feet tall and weigh about 50-75lbs each. Looking for non plastic replacement if possible

Need to purchase same identical parts. Need info on removing top and bottom rollers from existing closet door.

Need to identify this part and get replacement

UNABLE TO TAKE HARDWARE OFF DOOR AT THIS TIME. HOPEFULLY THIS IS ENOUGH TO IDENTIFY HARDWARE. THANK YOU

I need bottom roller for double entry doors. i believe the part is an acme part but i have had no luck with the folks that i purchased the doors from. if you need more photos or information, let me know. thanks for your help Rick

Hello I am looking to replace my track top and bottom for my 61" doors.

My sliding mirrored closet doors do not slide properly after 25 years of use. I believe the wheeled device shown in the pictures above have worn out. I have 2 closets so I would need 8 replacement devices. Also, I want to replace the bottom tracks on both closets. The tracks are white. one closet i ... (cont.)

Hello. I need to replace this part for a sliding mirror door.

Hello, I'm looking for a bottom track and 6 rollers for my mirror closet doors. It is Stanly/Monarch, 3 large mirrors on double track, with 1 5/8" span, in white. The rollers appear to just snap into the slots in the frame without any screws. I believe you do have corresponding replacement parts, a ... (cont.)

I have a Stanley/Monarch mirror sliding doors 48" x 80". The doors had been removed in a flood and now the floor track is missing. I need to purchase the floor track. Below are a few photos that may help. I have a handyman who will be installing. Thank you for your help.

Attached, please find: 1) picture of bottom wheel assembly. There is also a clip that holds the wheel in the track, and 2) cross section of the track. Track was damaged during remodeling. Please make recommendations for replacement. Thank you