Viewing all customer Discussions for:

23-051 Kenna Track Front Closet Door Hanger, 1/8" offset

Dear Sir, Could you please suggest me what part number I should place for orders? I need 2 of them for now. Thank you, Seiji

I have an old Kenna sliding door system in an apartment. The wheel diameter I need is 3/4". Are the wheels on 23-051 and 23-048 this size?

3 inches high,1 1/4 in wide 1 1/16 offset doors are 1 3/8 I think it was an ACME because the only marking is on the backside and is a capital A inside a circle which I think may be trade mark for Acme.It has a cam device to adjust the height of the door from the floor.

Hello, for markings, I found this on the wheel: Kennatrack Scottie It has virtually zero inches of inset (very slight) on the front hangar. Hope my pictures help. Thank you so very much !! Noel

Would you know what part I can use for this

We are trying to find a pair of replacements for the part shown. "Scottie Kennatrack" is imprinted on the side of the roller. The closet doors may be original to the house, which was built in the mid-1960s.

Hi..Have a part very similar to your Kenna 23-048 roller assembly. Mine has a W on it with a crown over the W and then it says 3/4 Front and 1 3/8 Rear...It is 3 1/2 in high and 1 1/2 wide. It is 3/8 from the back of the frame to the offset frame and 3/4 from the back of the frame to the middle of t ... (cont.)

When selecting the quantity, are these sold individually or in pairs?

Pictures of needed closet door roller. Is the 23-051 replacement hardware what Im looking for? It looks like it but ??? What do you think?

I need some of these see picture attachment The adjust part I can get by without, the thickness of the wheel is important or it will drag in track

I am looking to replace roller hardware on my bedroom closet wooden sliders. attached are pictures of doors and hardware.I just need the hardware with the 3/4 inch wheel at the top of the slider. The bracket is 4 inches with a 3/4 inch white wheel at the top. Thanks, Bill