Viewing all customer Discussions for:

23-051 Kenna Track Front Closet Door Hanger, 1/8" offset

I have some old Kennatrack door roller hardware, 1 inch wheels one with a half inch offset one with a quarter inch offset looking for a couple of replacement sets

Not sure about offset? Measure from counter to bend in bracket, not counting wheel is 1/2" is this something you sell? And if so please give part number. Thanks

Hi - I purchased 8 kenna track closet door hangers and received today. Unfortunately they don't fit the track - the wheels are wider and thicker than the ones I need to replace.The old ones have a wheel with width 3/16" and diameter 3/4". The new ones have width 1/4" and diameter 7/8". Can you hel ... (cont.)

On the wheel it says Scottie Kennatrack and on the back it says Kennatrack Elkhart

I need a replacement hanger for my closet door. Google Lens showed your Kenna Track Front Closet Door Hanger, 1/8" offset as the solution. The big box stores do not have my older than dirt track style/hardware. It needs to go straight up from the backside of the door and not bend. Thank you in advan ... (cont.)

I need replacement hangar for heavy, mirrored front sliding closet door. Original hangars are stamped "J673", 3/4 rear, 1-3/8 front". What can replace these.

Please help identify this part for purchase of a replacement

Looking for these

I noticed that the Kenna Track Front Closet Door Hangers in one of my closets are offset (pictured) while the others are not. The offset causes the doors to rub together and is pretty annoying. Are there any equivalent pieces without an offset that I could replace this with?

Looking for replacement wardrobe rollers as pictured. Thank you!

Hello, I have older door mounts that I am looking to replace. Dimensions: 1" wheel, 3 1/8" height, and 1" width. Offset: 1/8" and 1/2" respectively. Please let me know if you have anything available or where I can purchase those mounts. Thank you. Bob

I need to replace a wheel for the roller in the attached photos

Need replacement rollers for house built 1972 for hollow closet doors. Would yours work. My roller in photo

Need replacement assembly.

I have KennaTrack rear closet sliding door roller with a broken roller. Front-3/4 and Rear-1 3/8. What is the replacement part? Thanks, Paul

Hi, please see the attached photo. I'm in need of the tear-drop shaped piece. Sorry, I have no idea what it is called.

I have an old closet I need to replace the rear door slides and can not find any to fit. There's a A stamped on it with Kennatrack. Can you tell me what size I need? Thank you!

I am looking for the following Wardrobe Door Roller: Steel bracket (3-3/8" H x 1-1/2" W), Two slotted mounting holes, single plastic wheel (0.930" Diameter), w/ adjustable lever to raise and lower the door. PN: J673 - Front Roller: 1 - 3/8 PN: J674 - Rear Roller: 3/4"

Need to replace the four Kenna Track Closet Door Hangers on a 2 door built in linen closet in the master bathroom. The nylon wheel on the pictured hanger is very loose and will not stay on the track. Below are pictures showing the dimensions. It appears that the offset is 1/16". I look forward to ... (cont.)

I would like to buy the above A & B parts.