Viewing all customer Discussions for:

23-178 Rear Bypass Hanger, 1-1/2" Offset

They are old closet door rollers from around 1954

Looking for a zero offset roller for my closet doors I ordered 23-177 as it is only 1/16" offset and thought it had the best shot at working I also see 23-015, but i'm not sure

1 1/2" offset

Hello Swisco. Do you think item 23-178 and 23-177 would be appropriate replacements for the rollers in the attached photo? The measurments seem to be the same, however, i am not sure if the width of the wheel matches. Any guidance you can give me would be great. Thank you.

HI Swisco!I received an order a set of front and rear closet door roller hangers.I need the same offsets for both front and rear but need the smaller roller wheel (2mm) as these are for older doors and track.Picture attached.Can you help and thank yo in advance!John

Please let me know if you have any thing that would work. I am doing both doors so will be needing full set.

I am inquiring about replacing this closet door hardware. The door is 1 1/8" thick and the back track offset hardware is 1 1/8". I was unable to find the proper wheels with the matching offset. The doors are from the 50's with I believe to be original hardware. I found a "no 3000" as the only discri ... (cont.)

I am looking for a 3/4 in. offset version of the rear bypass hanger E-Z Roll model 23-178 (1 1/2 in. offset, backset), in which the base of wheel appears to be much closer to the top of the door than in the case of the Cox 3/4 in. offset, backset roller (Home Depot). Surprisingly, none of the suppli ... (cont.)

This rubber wheel roller is on heavy wood sliding closet doors from the early 1950's. One wheel is broken. Rubber Wheel is half inch wide. Straight bracket is two inches. Replacement plastic wheel seems to be too small for the heavy doors. Thank You.

Can you give me the thickness dimension of the subject hanger wheel?

Do you got these in 1-1/8 offset Thank you One is e-z roll Howe mfg inc The other is ?

These are similar to the type called Kenna but the front is ¼" backset and the rear is 1-¼ backset and they have a concave wheel and I cannot find anything to match. The rear wheel is reversed compared to most applications. Many thanks.

Looking to replace hollow doors with two panel old solid wood doors. Is there a weight suggestion on these? I'd prefer to keep existing e-z Roll track if possible. Thanks!

These rollers have been in the house since 1956. Can't find these anywhere based on my photos do you have anything like this? The medal bracket is flat

I have Leigh 1 3/8 rollers on my closet doors. I need replacement brackets but can't find the correct size in store. Are these still available?

Hello, Does the item Number: 23-178 (Rear Bypass Hanger 1-1/2") come in 1 inch? This is the size i'am looking for. The attached picture is the one I currently have. Thank you in advance.

Do they come in a 2 pack or single. I need all 4 rollers or a closet and I want to know if I need to buy 2 of each or 1. It doesn't say if it's a single or 2 to the pack

Hello, I need to replace these old rollers with new ones. I seen some on your site that were very similar. But the bracket was a quarter of an inch wide. I don't think it'll make a difference but I am not sure

cant seem to find these two rollers sizes

Looking for a 4 sets of these rollers. The large one has a 1"offset