Viewing all customer Discussions for:

23-186 Rear Closet Door Hanger, 1-1/8" Back-set

Need input on available replacement parts for 3 sets of closets door thickness: 1 3/8 inch thick front bypass door:1 inch wheel, offset 3/8 inch rear bypass door 1 inch wheel, offset 1 inch

It says Stanley on it.

Thank you for responding to my request. I am looking to replace all of the hanging roller assemblies for four closets. Each closet has two doors and each door has two assemblies for eight 'front' assemblies needed and eight 'back' assemblies required. I have attached a picture of two assemblies ... (cont.)

This rubber wheel roller is on heavy wood sliding closet doors from the early 1950's. One wheel is broken. Rubber Wheel is half inch wide. Straight bracket is two inches. Replacement plastic wheel seems to be too small for the heavy doors. Thank You.

On the roller: Cox & Sons, Inc. Pasadena Califon the plate that is screwed into the door: 1 1/8 REARIt seems close to your Product Code: 23-178, but the roller is different (?)Al

I have Leigh 1 3/8 rollers on my closet doors. I need replacement brackets but can't find the correct size in store. Are these still available?

Hello Swisco group, Do you have the Leigh hanging closet replacement rollers? It has a front dimension of 1 3/8" and a rear dimension of 3/4". I believe the part may be number 77-28287. thank you, Linda

I am trying to identify and obtain proper closet door replacement roller hardware for the system depicted in the attached sketch. The original brackets are missing on the outer door so I am not sure of their exact configuration. The OD of the existing inner door roller is 1 1/16" and it is 1/4" wide ... (cont.)

I have 2 sliding doors, made in 1955, which have wheels made by "Cox & Sons", Pasadena, CA. The 1" DIA wheels have NO ball-bearings and are badly worn-out, see 2 pix for dimensions. The spades are 1" wide. What are the right replacements WITH ball-bearings you can offer and at what cost, incl shipme ... (cont.)

I have a set of old closet doors. The rollers were kind of worn out. I'd like to seek for replacements. I tried to measure and draw the dimensions. Hopefully those files make sense. Thanks a lot. Amy

My Father Inlaw's house has failed closet door, I need to replace one of wheels that has flat spots. The local big outlet stores don't have parts that fit. Their wheels are too thick or too tall... Thanks, Stephen & Lauren

I have a set of sliding doors in a bedroom closet. The rear door of the set has good roller hardware. The front door of the set has no hardware, as it has broken throughout the years. The rear door hardware measures as the following hardware, found on your site. 23-186 Rear Closet Door Hanger, 1 ... (cont.)

Regarding your Rear Closet Door Hanger, 1-1/8" Back-set sliding door hanger: I'm trying to find a deep offset hanger that will give me more space between my bypass doors and this is one of the few I've been able to find. However, is it the case that this piece does not allow for tilt adjustment to a ... (cont.)

This drawing is of the mounting hardware for a rolling cabenet door. On the harfware it says, LEIGH