Viewing all customer Discussions for:

81-244 Sliding Glass Door Roller, Pella

Need the replacement part to order for this roller.

Which part is the best match for this Pella sliding glass door?

My close-up picture shows my rollers have a flange on them. will your 81-249 work for me anyway?

I haven't taken the rollers out yet (hence no photos) but I know the part number of the rollers I need. It is Pella Roller Part # 0FAT0000 (confirmed with Bella). Do you have these replacements? Thanks in advance.

I need two replacement rollers for my old Pella doorwall. Photos are attached. The dimensions are 2 and 1/4" by 1 and 3/4" by 5/8" thick with a flange.

The bearings are shot but the mechanism is good. Roller is 1.5" od

I have a designer series pella sliding door. I need to replace rollers. What roller would be right I haven't taken door off yet. Any good ideas for replacement the door was installed sept of 2001.ThanksDennis

Have 1986 Pella French slider door and trying find new rollers for them.

for a 35 year old 8 for wide Pella sliding door.

Hello I'm looking for Pella sliding door rollers and also bumpers for the top of the frame on track. Please see attached pictures with dimensions of the rollers and bumpers I am looking for. Thank you.

There is no markings on the roller assembly's

Just confirming that I have selected the correct part for my Pella door.

Can the roller in these be replaced instead of the whole part?

Part is 2 3/4 by 1 7/8 by 1 1/8 to 3/16 and the roller is 1 1/2 in diameter. I am wanting to replace assembly and I need to make sure what to order. Thank you.

I have a 4.5 year old Pella sliding door that is heave to slide. it is not binding or making any noise. I removed it and the dimensions are 2 3/4 by 1 7/8, the thickness is 5/8 with a 3/8 x 1 1/2 wheel. It also has a flange. You list 2 sets of Rollers a 81-098 and a 81-244. You have in the descript ... (cont.)

I'm looking for new replacement rollers for a Pella sliding glass door whose serial number is 16CFR 1201 II SGCC 1921 1/8U, with CTGB Tempered glass. It was installed in 2002. Do you have a roller that would fit this door?

Sliding double Pella Door, probably from 1990s

I don't see where replacement roller width is posted, what is inside width of the roller and will it ride on a 5/16" track? I am replacing rollers on a Pella wood frame door. See Photo. The "slot" the roller fits into is about 11/16" wide. Thanks, Randy

I have a 5' Pella sliding glass door that is used daily with the blinds between the glass that needs new rollers. I believe the door was installed between 1995 and 1998 - I think?? The door has just one hole on each side for roller height adjustment and it appears the roller assembly is 'pressed' i ... (cont.)

Rollers for pella sliding patio doors pre 1998