Viewing all customer Discussions for:

32-096 1-1/8" Drawer Slide Roller, Threaded Axle

Looking for a replacement for this roller. Any help is much appreciated.

Looking for something similar

I need four of these. I have one that is usable.

the plastic wheels at the ends of the rails are broken. Is there a way to replace just that paryt. if not, where to get the rail. Thanks p.s. pic is upside down, obviously alan

This roller/wheel is from an old Mayline flat file cabinet. It is 1 inch in diameter (or a hair over that) with a one inch screw. I see ball bearings?My local hardware store had nothing.:-) Any ideas on where I can source a replacement?

I need a replacement roller. It is 1" oval as shown in the pictures. I do not have shower door model number. But the glass is stamped. 16cfr120116cfr1201-II, ansi z97.1-2004, 5/16ua sgcc 3961.

This is a missing part of the shoe cabinet snd it comes also with a plastic screw that fits in it. I want the pair for this.

Another St. Charles part request. These stationary rollers support a blind corner drawer. 1-1/8" OD, 1/4" wide rubber tire. 3/16" cotter pin axle.

I'm not sure if plastic wheel can be sold separate. The bearing number is 608zz ABEC 7.

Broken roller (as pictured, the bracket is OK). I've found 3/4" but these are 1". Also as pictured, the area where the screw goes in is raised out 1/8" where the replacements I'm finding are flat.

It looks like they are about a 1" roller with a bearing and shaft. I have two that have been turned into cams instead of wheels! I'm also looking to replace the nylon latch insert that keeps the cabinet closed. I have resorted to using magnets, but if you have the nylon latch, I would totally repl ... (cont.)

What is the load capacity of the 32-096 roller?

Hello!I just placed an order for 2 of the1 1/8" roller for a drawer slide Below is a picture of The part I require.( the plastic on the roller has broken off) It is part of a 20" rail.image1.jpegCan you help me to identify the correct part?Many thanks!Lynn

Do you have 1.0 inch diameter drawer slide rollers. The 1,1/8 diameter slides I purchased are too big to fit in the rails

Hello! I'm trying to replace some drawer rollers from some old steel kitchen cabinets. I just received part #32-096, and they are so close! Yet the axle is a little deeper than the original parts so they make the wheels stick out a tiny bit too much. The rest of the roller seems to fit pretty well, ... (cont.)

I have exactly the same slide as here, and also need replacement wheels. I looked at 32-096, and they look like they would work with the exception of the 1/4 inch collar between the threads and wheel. These slides have this built in. Any chance that this can be removed or that (even better) there ... (cont.)

This is replacement roller bearing which is covered with a black rubber washer 1 1/8 inch' for the outside diameter. This supports a 1/2 circle lazy susan type corner cupboard. St Charles cabinets.

Looking for glide wheels for an old Anderson Hickey filing cabinet. The axle is 6/32 of an inch i diameter. The wheel itself is an inch in diameter and 3/8 of an inch thick. Thanks for your help.

We are looking to fix where this roller is broken off. Looks close to 1 3/16

I'm looking for rollers for this late 1950s kitchen drawer. Your 32-096 roller looked like it would work, but the roller width (9/32") is to wide. Is there anything thinner?