Viewing all customer Discussions for:

87-190 Double Roller Assembly, 1/2" Nylon Flat

We need a dozen roller replacements. They are approximately 1.5" overall length. We need 2 replacement latches. Thank you! Tom Warton

Looking for door slider rollers. I could tolerate a larger wheel as I have .5in at top of door. Thanks

From what I can tell this window was made in 2007. I have attached everything I can find out about the window. The housing for the roller measures: 1 11/16" x 15/32 x 13/32 and the roller measures 13/32 in diameter, wheel width is 5/32, and total width with axle is 9/32. If you need any other in ... (cont.)

I'm looking for 4 tandem rollers for my EPI windows.

The broken roller is on the bottom of a Simonton Patio Slider that is approximately 10 years old. One pic shoes the broken roller, the next shows the good roller and the last pic is of the sticker that I found on the door (don't know if it helps). I would like to purchase at least 2 of the roller ... (cont.)

I there are two kinds of parts I need for my Provia windows window limiter( stop lock) and brass wheel assembly hoping you can help me out with this thanks

I'd like two sets if you have them. Thank you.

Looking for replacement roller assembly for a vinyl window.

Windows installed about 20 years ago.13/32"deep, 3/8 "deep, 1 3/8 "wide

Need replacement tandem rollers for vinyl window

Windows 56" x 42" no markings , wheels have flat spots worn down. Roller insert 1 /2 "

Looking for replacement rollers for this Simonton window, and how to remove the old rollers

Ilay

Please help me identify the bearing replacement for my window. Pictures attached. Thank you kindly.

My Viking window is not sliding and I am looking to replace the roller on the bottom of the window. I included a picture of the roller and some measurements. Could you recommend a replacement part for my defective window roller.

I need the rollers for the bottom of the window I need the roller platform that the window sits on In need the vent lock The window is made by simonton

Hello, I'm trying to find a replacement part for a standard Pacific home window installed in 2002 by Pacific windows. This is a nylon double roller, grooved.

I am trying to replace my rollers that have flattened wheels. Looking at your catalog, I believe I need 87-190 but I would like your help and confirming. Thanks

Do I need to measure these, or can you identify without that?