Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

Need rear mounting bracket that drawer guide fits in to. It is plastic. Cabinets are 25 years old but still in good condition. See pics. Please include specific parts numbers so we can get this ordered. thanks!

I'm in need of a couple of these. Do you have them? I appreciate your help. Sheri

I need two pair of Merillatt rear drawer sockets. I will return item # 32-012. Could not use.

What are dimensions of the 32-119 bracket I need the inside dimensions where the slide goes in I sent you a picture of my broken bracket against a ruler

Old kitchen cabinet drawer slide sockets- most are broken, need six to repair 3 drawers.

Hi I'm looking for replacement brackets for sliding shelves that hold the arm up and fasten to the back of the cabinet wall. I have Merillat cabinets that are older. I have a number of 471037 that's on the back. What will work? Do I need replacement part 32-012 or 32-119? Please advise. Thank you. ... (cont.)

I need 2 pair of these and am not certain how to identify

One of our cabinet drawers is missing the backplate (unsure of the name of this part - a I'm a novice). It was never installed and previous (original) owners rigged it. The drawer finally gave way. I can't find an easy replacement anywhere. Appreciate the help!

Trying to find this bracket for a kitchen drawer. Install at back of drawer

Cannot not find any identifying information

Looking for replacement socket for slider kitchen drawer. The broken piece has a number on the inside. That number is 471037

This piece came off the end of the right side of a kitchen drawer which uses a rolling track for sliding the drawer open.

The stamp on the rails says uni grass 6600. We need the back rail mount. You can see that it has a knob on the back to fit into the hole on the steel backplate. Please help!!!

Help!

Can you possibly identify the attached part. We think the slide is approximately 20+ years old. Have a homeowner requesting a replacement for the rear bracket. Thanks!

Perfect size would be 3 inches long. Accomodate a 1 inch high track.

The end of the drawer tracks go into this plastic housing which goes into a metal plate on the wall. There is a right and left housing. I need several. Help?

I need two sockets to repair two cabinets. One is my mothers the tan one. They are Home Depot cabinets from the 90's. The other is mine. I am guessing also about the same time. We purchased the home in 2015. There are no trademark that I have found.

Hi, any help finding this part would be greatly appreciated.Thank you,Bob

Rear support for kitchen cabinets installed about 30 years ago. Beckie