Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

This piece came off the end of the right side of a kitchen drawer which uses a rolling track for sliding the drawer open.

The stamp on the rails says uni grass 6600. We need the back rail mount. You can see that it has a knob on the back to fit into the hole on the steel backplate. Please help!!!

Help!

Can you possibly identify the attached part. We think the slide is approximately 20+ years old. Have a homeowner requesting a replacement for the rear bracket. Thanks!

Perfect size would be 3 inches long. Accomodate a 1 inch high track.

The end of the drawer tracks go into this plastic housing which goes into a metal plate on the wall. There is a right and left housing. I need several. Help?

I need two sockets to repair two cabinets. One is my mothers the tan one. They are Home Depot cabinets from the 90's. The other is mine. I am guessing also about the same time. We purchased the home in 2015. There are no trademark that I have found.

Hi, any help finding this part would be greatly appreciated.Thank you,Bob

Rear support for kitchen cabinets installed about 30 years ago. Beckie

This glide holder mounts on a piece of wood on the back of the cabinet. The glide slides into the slot.

These are for drawers in a cabinet. Mounted through hole in side The extension pieces that hold rails are broken

I am looking replace a rear drawer slide mount bracket for bath vanity. See attached pictures.

Hi, I need boots for my kitchen drawer cabinet slides...... can you tell me where I might be able to locate some? Thank you for your time, Gary

My home has a ton of old blum cabinets systems. Now things are breaking due to age, wear and tear. I've been looking rear mounts for a specific slide. I took photos. I'd appreciate any help you can provide

This bracket fits a glide that is 22" long, 1" wide and 3/8" deep. I am having difficulty locating a bracket that is wide and deep enough to accommodate the dimensions of this older style glide. Please help.

G6600 Need this replacement set

The plastic drawer slide has a G on it, outside of that, the track is 1" and it is 2.5" in total length including the end protrusion

Would you kindly recommend a replacement rear bracket holder from circa 1997 Yorktown cabinets with the plastic bracket number on item G6600. Length out-to-out 2 1/4" by an inside opening for rail to insert approximately 3/16th. Actual out to out width varies due to designs and allowances for multi ... (cont.)

Good Afternoon,I would like to order a kitchen drawer support bracket that broke in half today. The bracket/slide holder is about 2 1/2 inches long and the drawer slide appears to clip into this bracket. I've attached a few pictures of the broken part as well as where the broken slide is missing fr ... (cont.)

Looking for 6 pair