Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

Need replacement right side

The plastic going into the wall broke away from the drawer side rail.

Bracket for a side mount drawer guide 2" tall 1.5" wide 3/4" total depth 2 round parts in the back stick out 3/8" past flat back. They are 1/4" in diameter.

I want to replace some drawer sliders. They have a bottom edge that the drawer rests on but the screws need to be on the side because the bottom board is not thick enough. How do I decide what length I need? The actual piece of metal on the slider in the picture measures 22 3/8 inches. ... (cont.)

I'm looking for the part in the photos.

I am in need of the rear drawer socket for a Merillat Silverware Drawer Cabinet. I have included pictures.

The socket we have is 3 5/8" long. 5 holes. The inside opening is about an 1", the outside opening is about an 1 1/4"

I need two of the plastic socket that attaches the drawer roller rail to the inside wall of the kitchen cabinet. This part allows the pull drawer to be anchored and slide open whilst nested in the cabinet frame.

The metal bracket is 23” long by 1” high The plastic bracket holder is 1 1/2” long by 1” high. Thank you.

plastic end has sheared off.

Looking to repair/replace the broken plastic slide mount for kitchen drawer.

I am looking for a rear drawer slide socket (pair). I do not see any markings on the hardware.

Replacement part

Ferrari GO23 (R)-(L) Both sides are broken, need a replacement pair

These two pieces were damaged on my wooden cabinet drawer. They are the right and left back support pieces for a drawer that has side rails with small roller wheels. molded plastic with G6600 markings measurements: back area to be screwed into back wall: 1 3/16" wide, 2 1/8" tall; opening for ra ... (cont.)

PLASTIC L BRACKET IS ATTACHED TO PLYWOOD WITH A SCREW. BRACKET CRACKED IN MULTIPLE BRACKETS. IS WEIGHT OF DRAWER CONTENTS STRESSING BRACKET TO CRACK?

Looks to have been glued in but not sure if that was intended or prior owner's attempt to fix previously (left side is glued as well, doesn't appear broken or at least functions well.) Socket itself is 1 1/4 deep. Including the knob at the end it's around 1 7/8. The knob slides into a piece mounted ... (cont.)

Hello, Im in need of a drawer slide socket. I took picture of it with Google & it shows as a 32-002 socket. Would you have any of these? I also attached a picture. I appreciate your reply.

One of our slide brackets has broken and we are looking for a replacement, or maybe several to have some on hand.Ideally we would like to pick something up locally, in Madison, WI but of course mailing may be our best solution Thank-you,Jill

Glides for the back of the cabinets.