Viewing all customer Discussions for:

23-250 75 lb Pocket Door Panel Kit, 36" Opening

I'm in need of 2 of these to hang a new door on the old pocket door track. Unless you have something better that will work

I need to replace this pocket door roller, actually I need 2 of these. Can I just replace the nylon wheel? I can't seem to find one that is 3/4". I need concave. 5/16 or so wide? Says ATC on the bottom of the metal part.Thanks!Beth

I don't any markings in this hardware.

Hi, you have always helped me in the past hope you can help now. The adjuster is not working. The photo depicts adjuster with 1/2" nut . The branded "Acme" thanks, Jack

I need to replace the rollers on my pocket door. They are 3/4" diameter.

This roller is at top of door suspending the door Head roller

The wheel broke off of one of the two metal brackets that were on my door. I have a picture of the metal bracket attached. Marking say Strato- Track Incorporated. Elkhart Indiana. 5-LH. Please help me locate a new one or two. Thanks

Originally, door slid on bottom guide and rolled on a single roller "missing" on one end and the "post" pictured on the other end. I don't have any remains of the missing roller, but my recollection was is simply facilitated the door sliding on the base track. If installed as is will still slide bu ... (cont.)

My name is Cliff. My brother Dennis lives in the house where we grew up. This house was built in July-September 1964. His grand-daughter pulled the door the the side and bent the part as shown above. It has since been straightened, but continues to have difficulty in opening and closing the door ... (cont.)

Seeking track for pocket door Track in photo measures 1 1/8" top, 1 1/8" vertical, w/3/16" lip - length for 2 8 door

I'm looking for replacement parts for the door hanger on this pocket door frame. There was only one left on the door slab. There was no marking or name on the piece.

Double rollers on single bracket - wheels look apx 3/4" diameter - nylon -not any real adjustment more than 1/8" or so. Would like to replace with rollers that can raise the door apx 1/2" as it is hitting floor.

Hi, I am looking for Bypass closet door hardware to match the attached picture. Wondering if you can help? Thanks!

I'm looking for roller brackets for an older pocket door. The wheels are inverted. And I'm not seeing anything like that on the website you sent me?

Looking for double wheelrollers similiar to 23-049 except wheels aren't offset Measures 3.5" long, base is 7/8" wide and 1 5/16" high. The 2 rollers are 2.5" apart O.C. I thought this was a common roller used awile back. Please help Need 2 pr

Can't find this roller do you carry it

I need two of these. When the wheels are on I have 5/8 on center. Your 23-193 is close and would do, but I need the track. You don't sell a track and the kit that you have 23-252 is just a little too wide and throws off my spacing. Suggestions or can your shop manufacture something? You're probably ... (cont.)

How do you adjust the pocket door rollers for in kit number 23-250?

I want to buy a 1"x36" railing to hang my closet door

Do you sell a kit similar to the 23-250 for a 24 inch door as opposed to a 36 inch door?