Viewing all customer Discussions for:

33-088 #6 x 5/8" Mounting Screw

I need to replace these rollers on my screen doors... By chance do you also have new replacement screws as the ones in the doors have been rubbing the track and are now worn out and need to be replaced also Thanks

Looking for 20 pieces. I believe these are for international single hung aluminum. They square the sash in the frame. Thanks Jim

The plastic pieces are broken and need replaced. I nee 2 of them. I also need the inner rail that mounts to the drawer. I have np part number but measured 21 3/4" in length. This part mates with outer rail part number 108755FL. Please help!

Please let me know if you have anything like this. Thank you Jenni

Window Keeper, Burnished Bronze, 5/8" 90-111....can you please recoment screws to attach the window keeper

I need about 24 of these little plastic guides.They work in tandem with your 32-030 center guides - which I just ordered a dozen of. The little side guides have broken on nearly all of drawers. They attach with a single nail and probably a bit of adhesive. I could find no identifying labels, etc. ... (cont.)

What size screw is used for short glass clip. I am installing beveled glass into a kitchen cabinet.

I need replacement drawer glide locks. These are approximately 1.75 X 3.75 inches. Installed with the cabinets around 2006.

I am going to install a swinging door between the kitchen and "office" and would like to have the door 'seal' somewhat when it closes. (center of jamb) Can I dado a slot and install a seal the door would stop at but go in our our? -or- What about a seal in the edge of the door for easier (more ... (cont.)

Hello, I am trying to repair four old wooden double hung windows in my garage. The windows have been inoperable for years. The mechanism for each window is some sort of spiral spring balance but they are all either snapped in two or severely rusted. The lower sashes are 12 pounds each. The to ... (cont.)

How would these slides be mounted on the bottom? Will any screw work to keep it in place? Thanks

I need to replace several window frames but preserve the wooden sashes because they are in one of several condos in a historic building. The upper sashes will be permanently fixed in position and I intend to fit the lower sashes with spiral balances.The windows are grooved already, so I can route th ... (cont.)