Viewing all customer Discussions for:

32-339 1" Drawer Slide Spacer

600.010/08.25-meploa

the spacers/brackets for one side of sliding drawer have cracked. If you look closely at photos you can see crack in each spacer. I need to replace these but don't know size or type of spacer. Tried to order online from another retailer and was sent the wrong product. Can you help? Thank you ... (cont.)

I need to replace the below part, which was installed on my KraftMaid drawers.

Need new part

We have a pantry with pull out trays, Ktaft Maid and the right front side bracket broke under the weight of the items in the tray.

Hello, I have Brookhaven cabinets and there's a crack in one of the brackets. I can't tell if the measurement is from the edge of the plastic piece or just the part that sticks out. What size do I need to get? Thank you

Hello, The attached photo is for a KraftMaid pullout tray tract supporter. It is on the top right side. Do they make this anymore and if not what could l use as a replacement? Thank you

I am looking for replacements for broken cabinet pull out hardware from 90's Woodmode frameless cabinet. The plastic strip is 22.5 "L x 3/4W x 1/4 D. The holes are 1.5 " apart. The part that supports the pull out is 2" L x 3/4 Wx 1 1/2 D (or projection). Any help would be greatly appreciated. Than ... (cont.)

Looking for ordering info for the parts in photo. Long upright bracket is 5/16" thick, and t-bracket extends 1 1/8". Thanks

Looking to replace broken plastic adapter for sliding shelf. 3 inches long; 1.25 inch between metal bracket holes; 1 6/15 inch from wall to bracket. What else do you need to know? Thank you for looking.

I am in need of 2 drawer track brackets. As you can see on attached photo I have 2 broken brackets. This is for a 2 yr old bathroom vanity.Bracket is approx 1.75in wide by 1.75in deep if that helps.Thanks,Dave

Do you have something similar to this part?

Hello, I am swapping drawers from one cabinet to another using the existing hardware including these brackets, pictured, and 21 5/8" slides. The slides are mounted to the cabinet using these two brackets on each side (one in front and one in the back). Using these brackets, the width is about a 1/4" ... (cont.)

I ordered a 32-339 thinking I could use a spacer, but the screw holes don't match. Is there a better match?

Need a replacement for this piece, having trouble identifying it. Thanks!

We are unable to locate part numbers or the make of the cabinets. The piece we need is approximately 1 and 3/4 inches long. The plastic piece supports the cabinet glide. If you have this piece we would like to order 4 of them.

Need new bracket Thank you Joe

I have Brookhaven kitchen cabinets and one of the slide spacers is broken. What is the correct part number for it. To help me assist, I am attaching a photo of the same. The corresponding measurements on the slider in our Cabinet drawer are 1" 2/16 in depth and 1'.5 distance between two screws spac ... (cont.)

Not sure what to call this -- it mounts a drawer slide at the front to the side of the cabinet -- the post projecting out fits into one of two holes in this (Kraftmaid) cabinet from a circa 1999 or 2009 remodel (before we bought the home). The slide is suspended about 1/2" from the cabinet wall. Th ... (cont.)

Trying to find replacement parts or start over on a broken shelf.