Viewing all customer Discussions for:

32-339 1" Drawer Slide Spacer

Hope you can help, we need both lengths drawer glides 17-3/4 & 20-3/4. 4 sets of each. also need 8- 1" plastic spacers to hold glides at correct width

I need 1 pc of the item shown.

I am looking for drawer slide spacers that are 2 inches long. The ones I have seen advertised are only 1 3/4 long so the holes don't match up to the pilasters that are attached to the cabinet and they need to be 1 3/16 high. The ones that were originally installed are cracking and breaking. ... (cont.)

Hello, I'm looking to match this bracket that holds up my sliding cabinet drawers.

Looking for attached part

Looking for a spacer for a pull out cabinet drawer. Needs to be strong as drawer holds approx. 25 lbs. The drawer slider brand appears to be Mepla (Made in Austria).

Cabinet bracket is held by a small plastic part as seen in the picture. I am not able to find a replacement. Cabinet maker has been outbid business for many years. Local stores do not carry this part. No numbers on part.

Enclosed are pictures of a good bracket which is a side mount support for a kitchen cabinet drawer. Hopefully you have it and I can purchase 3 of them for broken replacements. Bob

I'm trying to find these that are 31/4 tall , 1 inch wide spacer

We'relooking for drawer slide spacers. We have 8 that have either broken or are severely cracked. These are for Brookhaven cabinets installed, we think, in 2009.

Does drawer slider Spacers come in cream color - specifically in my basket I have 32-339 and 32-352B - 6 of each, I believe they are white but was hoping for cream color

This block attaches the front end of a euro-style drawer slide to the front of a face-frame cabinet. It has no numbers, names or markings. It is about 1.3 inches thick at the deepest point. The back of the block atteches to the side of the cabinet and the front edge (where the slide attaches) is flu ... (cont.)

I am looking for kitchen drawer guides

I need to replace a Mepla side rail tsliding track support for a pullout shelf that is installed in a Kraftmade cabinet in my kitchen. It has a serial number or product number printed on the backside of 600.010.08.25. The number is visible in one of the pictures located above I have checked many ... (cont.)

I have the drawer slide spacer similar to your 32-339 but mine is 1 1/8" including base. Can you help? Thanks, Tom

This is the front left support bracket for a Kraftmaid Roll Out Tray. The tray is 31" wide and 24" deep. Kraftmaid's website does not show this particular support bracket. The one that is shown on the website is not the same shape. The photo showing the removed bracket shows 2 separate pieces. That ... (cont.)

Need to locate 4 drawer slide rear support and mount brackets. Willing to buy the complete drawer slide kit if necessary. These came on America Woodmark Corp. kitchen cabinets in the year 1990 purchased fro 84 Lumber in Jacksonvillle Fl. Cabinet part number is ROB30 Pull out base. Thanks for any as ... (cont.)

Hello,I have Brookhaven cabinets and as shown in the pictures above, the part that holds the sliding "rail" up, has snapped and now the drawer cannot be pulled out. The drawer otherwise is fine, but I need to replace the part that is screwed into the wall of the cabinet and holds up the sliding rail ... (cont.)

I need the space mount for the unigrass 6600 drawer slide