Viewing all customer Discussions for:

23-409 Corner Connector

Hello I need the slider on the bottom right. Thank You

I need two of these replacement parts

Hello, I'm looking for the missing parts for this door. I think it might just be the missing snugger? Or assembly that holds the pin in the track. There appears to be a spring already in the track, and one half of the door is still attached (fixed in place by a screw it appears). Any help would be a ... (cont.)

I know I have purchased these parts from SWISCO in the past but can't seem to find the part again. I have 2 corner reinforcements that have failed. They are made of plastic and fit into the corners of the panets to prevent the door from sagging. Needless to say, the door is sagging. ... (cont.)

This is the mechanism on the part of the door that slides in a track. The door keeps coming out of the plastic roller. Not sure but perhaps the whole mechanism needs to be replaced?

I am not sure what is the manufacturer. It woulb be great if you could find it.

I need replacement parts for my mirror bifold door. They are the corner plastic locks that hold the hardware in the middle blocks that connect to the hinge or the door folds and unfolds.l

I have bifold mirrored doors manufactured in 1999 by Contractors Wardrobe (CW). The pivot bracket on one side jumps in the track, and the door will not open or close properly. The bottom track appears to have spread. The hardware appears very similar to Stanley hardware - perhaps manufactured by ... (cont.)

This is the part inside the bottom of the door, first one is good, second photo is broken off. Pivot of bi panel mirror door. Please help!

I have a bifold mirrored door from indenpendent mirror co . The door is not functioning correctly and i believe I need to replace these parts but I cant find them . can you help

I have large bifold merror doors that dot open and close correctly. I was told that each bifold should have one of these on it. Is that correct?

The pin on my mirror bifold broke. I need a replacement corner connector to match.

Hi, I need the top roller pivot to fit s Renin mirrored bi-fold white metal door with a 7/16" diameter hole and 7/8" O.D.THE ROLLER IS THE THIN ONE. Nothing the usual replacement size.Thank you!

Hi I am looking for the bottom right side (looking at mirror side) pivot pin for this Renin 36 in X 80 in mirror bifold door. They were removed for a mold remediation and contractor lost the bottom right pivot pin. I would like to purchase the bottom right side pin and roller that goes in floor ... (cont.)

Do you carry this parts? This go on a 36" bifold mirror closet door.

I have older mirror bifold glass closet doors doors The opening is out of square, unfortunately. We bought a package of roller replacement parts that fit a 3'8 hole I am seeking a replacement roller pin that fits a 1/2" hole. (not the common 3/8") If the pins are longer that would also help. D ... (cont.)

3 inches wide and length 2 1/2 inches with screw I need the internal parts as well of the picture and screw This is a picture of it.

i need the part that goes into the black part that into the gray part that has a part that has a thing that fits inside the black thing

Hi, We have some mirror bifold doors that we believe might have originally been installed with Swisco hardware (though not totally positive). I've attached images of the missing components (the black box plus pin + nuts). It is the on the bottom track. Let us know if you are able to recommend a repl ... (cont.)

The hard plastic roller wheel broke on my bifold mirror closet door. I only need a set of replacement roller discs not the entire assembly. Thanks for providing this excellent service.