Viewing all customer Discussions for:

90-301 Face Mount Keeper, 1"

Lock / Latch for Jen Weld window part number 2600-402.

This part is a face-mount window keeper

13008-1

Hello. The pictures attached is the locak and latch that needs to be replaced. Would you be able to identify or recommend a replacement?

Can you tell me what part to order to replace the one with the number on it?

We have a double hung window that parts have failed. We need parts for the upper and lower panel. I have more photos but could only upload 5 at a time. ThanksJennifer

the keeper slides into the window, holes are 1" apart, from center of hole to the top is 1.5" it is also 1.5" from edge to edge. The lock holes are about 2 and 1/8 from center to center and 1/2" back to center of hole from keeper

Window keeper 1" × 1" 1/2

We need the latch pictured that fits with the attached picture of the keeper. There are no markings on amy part of it.

Double hung windows in mobile home. Window manufacturer unknown. Keeper built into slot in bottom of upper pane.

for double hung window in a college

Searching for this part.bought house 2018.know nothing about the windows.have not taken lock off yet..thank you for any help.

Do you know where I can find a replacement part for this?

I did a research and I found out that the window Face Mount Keeper I am looking for has been discontinued. Which one may be closed to the one I am looking for that could much?

I am looking to replace one of these Cam Locks that were installed in 2019 with 3 Replacement Vinyl Windows. I posted the Cam receiver so you can see what the Cam actually engages with. I have not been able to find anything close with a 2 inch hole spacing. The screw hole set back is 11/16" which se ... (cont.)

Need both parts - the lock and the plate the lock part goes into. Overall The lock portion is 2 7/8" long x 1" deep

MI windows suggested that I reach out to y'all. For mi windows because these parts are no longer manufactured by MI Windows and doors. GA5500 is the window series that is installed in this house. I have one window with missing keeper or receiver. I have sent pics .Thank youEdward ... (cont.)

I believe the link below is the latch piece I need. I attached two photo's from two windows, one is broken and one is fine. https://www.swisco.com/Keeper-Face-Mount/pd/Hung_Sliding-Replacement-Sweep-Locks_Keepers/90-263 Another question - if the windows won't hold open all the way (some slide down ... (cont.)

Jeld-Wen double hung window lock

Need replacement parts for the sliding window latches. The lock hasp is sheared off.Dimensions and arrangement is as shown in photos.Shishir