Viewing all customer Discussions for:

32-349 Soft Close Concealed Hinge Set

Do you have these. Hinges

This Mepla hinge is 4" long when fully extended. The body of the hinge that sits on the door is half inch deep and the screw holes roughly one and7/8" apart on center. "41 M" is stamped on the reverse side The tail of the hinge attaches to the armoire sits on a plate.

need two cabinet hinges for my corner lazy suesan bi doors.

Need a replacement hinge for a console cabinet purchased from Costco.

I need 1 replacement hinge like this, that has the quick release button on end.

We are in need of 2 old Blum hinges... or something comparable... 262347... the other number on it is 80-550-01. Can you help?

I have a pair of Hettich hinges. Looks to be stamped 04666. Do you carry these? Thanks, Craig

1st pair needed for corner kitchen cabinet Replace broken Mepla, one side reads 53.20 664.265 Other side reads 346.290.88.00 sent pictures Second pair needed for bathroom cabinet door replace Amerirock, 2019E 5.0 MM sent pictures

NEED TO ORDER GRASS 1006

Is there a replacement for the compression type hinge. Most that I've found requires screws to attach hinge to door. The wholes where the screws would go are very oversized. There is a word inside the round area of hinge "Toic" I believe? Hinges for kitchen trash cabinet are going bad home was buil ... (cont.)

Hello- I need a replacement for the attached kitchen cabinet hinge. I believe it says Quaker Maid. There are a lot of numbers on the back so not sure which is a serial number. Do any of these help? 6970436000 6982435900 5112430192 Thanks for your help!

Can you please match these hinges made by Kea? Thank you!

I am looking for this type of door hinge.

I have a kitchen cabinet about 40 years old. The screw in part in the second picture is missing and I need a replacement. The hinge itself is shown in the first picture. The plate on the cabinet side is marked as 317.293.50.00. I just need the part that pushes the hinge from the plate. ... (cont.)

Hello,I believe these hinges are Mepla Hings 698.243.59.00. I understand that they are not made anymore. Do you have anything that comes close to them that could be used as replacement?Raymond

These cabinets are around 35 years old. Some of the hinges need to be replaced. Do you have replacements that would work? The holds are approx 2" on center. If you blow up hinge pics there are numbers but hard to read.Numbers and "made in" you might identify.Jerry

I am looking to replace my hinges on a lazy susan kitchen cabinet. The brand name is Blum,# 78M 810 I think, see attached picture.

My whole kitchen was redone in 2003 and the cabinets have MEPLA hinges like the photos below. Need to replace some and cannot find any that match. Can you help?

I can't find any markings. There is a spring at the end to release the clip.

can you help identify this? Al