Viewing all customer Discussions for:

32-028 Rear Drawer Track Socket

Please help identify this part. It has 4 holes.

The drawer rail bracket at the back of a long narrow drawer in the bathroom vanity broke where you screw it in. The rail is a single center mount vertical rail. The part says US Patent No. 3090662. I purchased a part from another company but it is about 1/8" smaller. The only part I found on your we ... (cont.)

Please ignore the duct tape I'm not able to get the dimensions at this time. I thought you might have some thing that could work.

The pic i attached is of the side that is not broken. I just need the plastic bracket that holds the rail in place.

I have searched with no luck. Florida home built in the late 70s. Original drawers throughout the kitchen and bathrooms all have same sliders. I added a picture of the slider beginning in hopes that this might help.

The pictures are for the back bracket, need a replacement to fix the side that is broken. Quantity needed 4

Trying to locate a rear drawer guide bracket.

These brackets are from an older Grass side drawer mount system. G 6601 is stamped on the part. The size of the base is 1 1/8" x 1 3/4" and guides 7/8" high. Right and Left needed. Hopefully you can locate or have a suggestion for a substitute.Thank youFred

Require 4

The piece to hold one side of my kitchen drawer slide broke. I need a replacement. Can you help? Thanks

I have a custom cabinet built in the 1990's. The drawer slide plastic parts are breaking. The first part is the actual slide I believe PPhoto without the screwdriver). On the item it has 4 lines with Line 1. Delta Industries, 2. L.A.CA. 3. Ser.50. 4. 1The second part (near the screwdriver) also ha ... (cont.)

I'm looking for help in finding this piece to fix my other drawer. Dimension width was about 1 inch inside plastic piece. I don't have any part information other than the table is a broyhill that we purchased new 20 years ago.

Can you help me identify this piece? Don't know where to find a replacement. Plastic cracked.

Slide is 1 3/4" high, slightly less than 1/2" wide. One slide on each side of the pull out drawer (four total). The bottom of one existing bracket snapped out causing the drawer to fall. Accuride slides. 23" long.

The drawer slider inserts into the socket and the socket can slide left to right a little inside the bracket. The slide that goes into the socket is 1 3/8" tall. I ordered part 32-003 and the slider is too big for the socket.

This white part is plastic and broken. I need one and hope you have one.

From kitchen drawer with 1 inch side rails Need the white plastic support piece holding the metal slide rail Piece measures 2 .75 inches which is top to bottom and mounts to wood frame at the back Need a left and right set

Bracket for slide for drawer. No markings on part, part fits either left or right side.

similar part to product code 32-139 except the 13/16 dimension must be 1 inch+3/16. All other dimensions ok. I need qty 4 to replace parts install 30 years ago. If you don't have part any suggestions? The old part has no part no. or mfg identification.

Hello, I'm hoping you can help me with this. I can not find this part anywhere.Thank you,Judi