Viewing all customer Discussions for:

81-182 SS Patio Door Tandem Roller, 1-1/2" Concave

Is this available? Heavy hurricane impact door on beach.

I'm dealing with a Guardian Patio Door from 1975. One door is stationary. The rollers have a mounting screw on the latching edge as well as non-latching edge. On the front of the door, on both right & left ends at the bottom, are holes with caps inserted. Behind the caps are adjustment screws, w ... (cont.)

Trying to find replacement for these rollers. Wheel Diameter = 1 7/16"~1 1/2"; Width = 3/4"; Height = about 1 1/8" at the highest point. Wheels are metal. I measured the Height at it's highest point

Hi Tom here,Picture of roller attached. Matches product 81-182, except for the plastic top piece? Any ideas? I had to re assemble the door, but maybe the plastic piece can be removed and added to the new rollers?Tom

6 1/8 inch long, 5/8 inch wide

Hello, can you identify the correct part for us to order?

Hello - I'm considering purchasing "SS Patio Door Tandem Roller, 1-1/2" Concave Product Code: 81-182" I purchased Primeline part like the above, however the housing is too wimpy, it isn't strong enough. The stainless steel part attached has a stronger housing, but I need the tabs to be like the zi ... (cont.)

Looking for appropriate rollers. A few match not sure if there is a big difference between your 81-182 and 81-149. Thank you

We purchased a house and the patio door is super hard to open. The track comes out and it is apparent the front roller is broken or off track. Can you direct me to the type of rollers and replacement track I would need? I need the track actually as well. It is broken It is an 8ft piece There ... (cont.)

Looking for sliding door roller replacement for Jeld-Wen 2021 patio door.Photo of roller screw adjustment location.

I need to replace the bottom rollers on the 36" x 80" operable side of a 72" x 80" sliding insulated vinyl frame glass door. The door was made by Summit Windows in Spokane, Washington in 1995.

There are two of these on this door. The photos are from the one that works, the other is totally frozen up. No discernable markings on the unit

Hi there - we need 2 of the attached rollers. Specs are: Width - 5/8" height - 1 3/16" Wheel diameter - 1 7/16" Material - metal

Sorry I believe the rollers are 1 1/2 and 5 3/4 hole to hole.

I have a customer who was installed years ago before our store opened and a different location had done the installation. The customer is requesting replacement rollers but due to lack of information provided when I received the file and no serial numbers on the products we are running into dead end ... (cont.)

Hello, I do not know the manufacturer of the sliding glass door. The door has two holes in the front and no screws in the sides for adjustment. So, I think it uses one of the tandem roller designs that you have. I think it is one of the following: 81-018, 81-128, 81-141, 81-149, 81-182, 81-188. A ... (cont.)

No manufacturers marks visible on the roller units. Mounting holes on the mortise lock are 4-5/8 on center. Doors were made by a new york company, Challenger ?

Del Mar double rollers. Part 53765

I need to replace two roller sets for my Marvin clad ultimate sliding door as they rusted in a flood. The model number on the door is NFR 269/270 and the catalog number was CN 5070.