Viewing all customer Discussions for:

23-098 Mirror Door Roller, Concave

I am looking for this parts. I need a set of 2

hi, I would like to order this part if you have it. It says contractors and wardrobe and has phone number but can't find a part number. it looks like its brass with plastic wheel 1.5 in diameter for a closet door. Thank you!

I need 4 or 5 of these rollers. They are part of the whole assembly, but that is all I need just this bottom part with the roller Thank you

I need a 10 foot long track appropriate for the rollers shown in pictures

My wheel slid out when I partly lifted to disengage from a shoe that got caught under it. One other roller doesn't roll as easily so I thought to find a replacement part. I's this something you carry?

Hello, I'm looking for replace the rollers. He hole pattern is 2.5" x 1.3", 1.5" OD concave roller, the assembly is approximately 1/2" thick. What would you recommend? Thank you, Mike

It's similar to your 23-064 but not same dimensions

need part number w8020 assembly wheel for cw sliding glass mirror door

Contractors Wardrobe P/N W8020. Which of your rollers is the correct replacement.

hello my name is manny I ordered 4 mirrored closet door rollers some time back and I received the incorrect ones which I would like to return and need return information I'm sending 2 photos of the correct ones that I need I need a total of 4 thank you

I need eight of these with a tracks totaling 142 inches. Thanks

Hello I believe I purchase the wrong item. Below is the part I need. Will the one I purchase be compatible with this one? I was also instructed to review part 23-285, however, the wheel is different and I do not think it will work. Do you have a replacement that will work?

Have attached picture of original roller From roller to end of encasement measures 3-1/8" Width of encasement measures 1-3/4" Cannot find any brand or part number. I have two sets of mirrored bypass doors that I have painted the metal trim white. Need to replace rollers and track. ... (cont.)

we need a replacement for the closet door part.

I believe I can use the wheel assembly in 23-098 as a replacement for the wheel in the pictured assembly. The housing on mine is different because it snaps into the door, does not screw into place, so I would just extract the wheel and slide it into my housing. (Unless you sell the wheel assembly as ... (cont.)

I don't know the name of the mirror doors that are on my closet. Hopefully you can help me with the picture of the part.

I' think it's likely to be your 23-098. My concern is the offset depth. It can't be more than 7/16. Not seeing any measurements on your rollers

The wheels are 1.5 inches and concave as seen in photo. Hole spacing seems to be about 2 1\2 inches. Came with house built in 1990. No brand name or number othe than "A.C.E Inc" stamped on wheel housing. Note exact arrangement of holes and how it mounts for nylon top guide Can you help please ... (cont.)

Have a set of old circa 1991 I believe monarch mirror sliding closet doors. Track is shot and seen better days other than that I cleaned the rollers good and they seem to spin ok. What track would work for this old setup?Also, this has the concave wheels which I would like to replace as well, see at ... (cont.)

Closet door rollers W8020 or W8025