Viewing all customer Discussions for:

32-030 Rear Drawer Guide

Please take a look at the attached photos and let me know if you carry this part. The replacement parts Swisco sent are too large for my application. I ordered item # 32-031 (Rear Drawer guide.) The problem is that the broken guide is smaller than the replacement sent. Please see photos. Please let ... (cont.)

Hello, I hustled purchased 4 slides that were the wrong size. The opening I need is 3/4 in.

Hello the photos below are what Im looking for and I feel your drawer guides would be suitable . Do you ship to Australia. Also Im looking for the timber guide rail? Look forward to your advice

Can you tell me which replacement part is required?

I measured the existing guide, the opening left to right is 3/4" wide, will 32-030 be the one I need?ThanksBarry

Just purchased 9 rear drawer guides, 32-031, thought I had measurement down but I was wrong. Here is a picture for what I'm after. I need 9. Can you help us or give us a lead?

I have a plastic track that measures 3/4 inch. Will this 32-031 guide work? If not what would you recommend? Thank you

Looking for this guide. Bottom drawer, mounts in the back top of drawer Thank you Tim COBPC

I have a childcraft 6 drawer dresser. The plastic tabs on the bottom/back of each drawer are cracked or missing. It's the piece that hooks to the wooden track in the bottom middle of the drawer space that keeps the drawer from rocking. They are kept in place with staples. Can you help me f ... (cont.)

I need to replace these on a dresser. The plastic guide runs along a wood slide. I want to purchase 4.

I have reiss r-26 and wooden slid is broken Do you have them

I am searching for the same guide,my guide has a 1/2' space between the guides, do you have those in stock?

This morning when I closed a drawer in my pantry it went down instead of forward. I took out all the drawers-wood glides above center of drawers. The width of the wood is about 3/4". I bought this house recently, and am unfamiliar with this system. Do you have something that wood work? ... (cont.)

I need a dresser rear drawer glide with a half-inch opening for a three quarter inch rail. My old part has no markings. what part number should I use for ordering? Thanks!

I'm looking for rollers for this late 1950s kitchen drawer. Your 32-096 roller looked like it would work, but the roller width (9/32") is to wide. Is there anything thinner?

I am looking for the drawer slide replacement part shown in the first pic for a Childcraft dresser/changing table combo (shown in the second pic). It was purchased in 1989. Thanks!

White one is Reiss Mfg. R26. Pat # 2557233. 1 3/4 " height, 2 " w, 3/4 " opening. Red is mfg by slide-co. Fits 1/4" x 3/4 track. Length is 1 5/8. Holes don't match up. Just a little off. Do you have anything that matches up to the white one Thanks Sue

Hi there I am looking for 9 of these white plastic glides that have the following on them: R-26. Pat 2857233 Any help is appreciated.

please see attached measurements. There is also a little ledge the bottom of the drawer sits on.

Pmc 2 looks like your guide 32-030 but measurement of section that actually glides on wood slide is different.