Viewing all customer Discussions for:

Door & Window

Donna- need help finding a new cranked

Alside vinyl replacement

Hi I'm looking for replacement hinges for my basement window the markings on the hinges is Interlock 12c-is23 HI

Hi. Had a hail storm of biblical proportions recently that holed a number of the plastic inserts along the sides of my Alenco aluminum windows (windows circa 1998). I have no idea what these pieces are called, but they are simply a curb for the screen frames to sit against. Are these obtainable? ... (cont.)

Need parts

Broken glazing bead on alencoe slider

HelloI need four of these metal rollers with ball bearings. The largest diameter of the roller is 1.5 inches. If possible I would like the entire assembly per the photo, not just the roller as the "housing" is rusted.Thanks for your help.Chuck

Hi, I need this part to replace on my window. It has no markings on it and the window channel is only 7/8" wide. Thanks.

I would like assistance in identifying a replacement wheel for the following dimensions: Wheel diameter - 1.5 inches width - 13/16 height - 1 and 1/8 inches

Has this Writing on it KT B 1

Need correct coil balance shoe and Pivot bar that goes to it Also both left and right latch

Could you please help me identify the following double hung window latch. Thanks. David

Window won't stay open, I assume cord is broken. What do I need

Hi, My daughter recently bought a house and found that the handle and latch on the sliding patio door needed to be replaced. It's a Guardian door but we can't read any other of the numbers because the etching is upside down and backwards. Attempts to take a photo of the etching have failed. I've ... (cont.)

Snap lock that allows window to be open about two inches and no further. It no longer stays closed to fully open window. Where can I find a replacement?

steel balance for american window white rh side metal sping

I have Marvin windows manufactured in 1990. The windows are fine, but the screens have pull plugs, and a number of them have failed, looking to replace. the screen frame width is 3/4 inch. the pull plugs measure 1 9/16 inches. thank you for your time/advice.

I need to replace a set of channel balances. They are 23 inches in length with a stamp 22e on they are approx 1/2 wide and 1/2 deep. Please advise. 23 inches in length. 1/2 wide 1/2 inch deep.

I need 5 right and 5 left arms.

Insulate Industries roughly 20 years old I need three 26 4 BSI VC