Viewing all customer Discussions for:

Door & Window

Hello, Do you have seal for a Series 8670 patio door? There is a deep groove around the exterior face of the door it clips into. The seal is foam wrapped with vinyl and a bead that clips into the groove. Thanks for the help, -AA

I bought your turn clip, rivet tool, and pop rivets in order #2341611 and viewed the video on how to install. Unfortunately I am having difficulty removing my existing pop rivets to get to where your video starts. I used a 7/32 drill bit (did not want to enlarge the hole so I went slightly smaller) ... (cont.)

Thank you

The stamps are pretty worn on both of these - I was thinking they are 727 ?

I am looking to identify the correct part to replace the title shoe on my vinyl window. Because they've been damaged, I needed to take the photo in place. Can you identify? The warranty number/brand information is also included in a photo. Thank you!

Several balances have failed and I need to replace them but I don't know the window manufacturer or balance number

I like to order this part if you have it please

XA on the side. Numbers 1 through 12 in the small circle. 2 capital i's. Made in New Zealand PAT. PEND

I'm looking for replacement tilt latches for my windows. I saw that you recommended 26-243 and 26-244 for a similar post. My concern is that the smaller portion of the triangular latch piece, listed at 3/8" in your diagram, is smaller than what I measure mine at (13/32"). The difference is minor, bu ... (cont.)

How do I remove the sliding and stationary sections of this sliding door? 4 pictures attached

Is this your item? How do you replace it?

I went to close a window and heard what sounded like a spring snapping sound and I couldn't close it all the way, so I took everything apart and found that the string in the balance had gotten tangled and I didn't want to try prying too hard and risk getting a spring to the face. I found your websit ... (cont.)

The door was drilled to install this all on the room side of the door without having to install interior parts to the glass door. Only marks are: Canadian Patent No. 919213 Patented: 1973 PAT. No. 3,596,954 Looking for a replacement that could mount the same using same holes and with similar desi ... (cont.)

The existing mortise lock is worn out and needs to be replaced. The mortise lock matches the 40-194 dimensions. Do you have a complete lock set to replace all of the existing hardware?

Hello, Swisco team, I need to order the part number S770-32, but I need the 32G option. So you have it available or do you think 32D will work? Thank You.(Debbie)

Metal length is 26.5" Need 14 One kitchen window is 13.75"

I am looking to buy 358-1L window roller locks.Victor

Looking for replacements window latch. Side to side is about 2.75 in., though angles out. Center to center of holes is 2 and 1/16th. Front of latch to back is 1 and 11/16th. Holes are 3/4 in from front and located closer to back. Color is beige. Hope to find exact replacement or close. ... (cont.)

window components, replacement window balanceThe balance channel is stamped "24 J" and measures 25"L x .56"W.The window weight is 16 lbs.

No brand visible. Only the crank broke off of the componenet