Viewing all customer Discussions for:

Door & Window

5 inches long by 3/4 wide high 1 5/8

This balance is 0.5" wide, 1" thick at the bottom, and 35" long. As you can see, it is stamped with "3465" at the bottom. I am wondering what type of window channel balance this is so I can order replacements. Thank you!

Sdg r25 5000 needs rollers and lock handle

I am looking for replacement window operators. They look to be Truth 41011 and 41012 as seen stamped on the bottom of the operator arms. Do you carry this brand or anther like for like replacement?

Can you help me find a replacement for this? There are no markings on the window that I can find. The psl on the other side is broken to bits. Thanks!

I need the bottom rail for my client I hope you can help me to found the correct rail

Need to replace the sash balancer

Need 2

Hello. We are looking for a replacement mortise lock for our sliding patio door. The information listed on our current part is as follows: Interlock patent 5,951,068. Thank you.

12 inch measures the metal only. Stamped 1120.

I have an old 1960 Burval glass sliding door. The opposite end (the side that doesn't have the door handle),the latch hook broke. 3 inch length between holes for latch and 0.5 inch width. The latch is connect with a flat handle...which has 4 1/8 inch between holes. Do you have a replacement? ... (cont.)

Sliding window roller

Trying to repair several double hung tilt windows. I think I identified the tilt latches correctly; they are the thicker ones so 26-243 and 26-244. However, several of my constant force balance assemblies are a mess; I had a guy out here who told me I needed "double 3/4 inch constant force balances" ... (cont.)

We are trying to replace these springs on our windows .When we removed Sash the springs fell out we need help locating correct springs.

We need a latch for our patio door. Top to bottom is 9" 5/16. Do you have any?

Seeking a coiled spring to replace the broken one shown in the attached images.

Looking for a replacement

Hi This crank was on casement window. The dimensions seem the same when measured with Dimensions for 39-031 part But the holes are not the same. mine, as you can see has only 2 holes on each side The long arm measures 10 3/4 and the small arm is 47/16

The roller axles/pins/screws are gone and the brackets slots worn out. Are these replaceable parts? Additionally, does the lower frame have to be removed to accommodate the parts replacement? Attaching the only identifier.

Says 2390.26. Shoe size 1"