Viewing all customer Discussions for:

Door & Window

Looking for a few of these.

Hello I have attached some pictures to see if we can find a replacement handle for the following window. The only Identifying numbers found on it is. 0P06754208Please feel free to contact me if you have any questions. Thank youMichael

Clips holding the top window. To open the top window those clips or locks, have to be unlocked by pulling with your fingers.

I'm looking for this profile rubber weather stripping. It fits a 1/2" deep X 3/16" wide aluminum track, 14-1/8" long. I need 2 of them if possible. Or please point me in the right direction. Dealerships and parts store don't stock it fyi.

Thanks

Looking for these clips. They stop the balancer on a non tilt window.

Binnings Pan American Model Pa-14 SH Length of balance actually measures to 30 inches

Hello, I wondered if two parts you offer will fit each other: Single arm window crank-part #39-216 Crank Hand Knob-11/32-part #39-115 Thanks,

Window latch on double hung window

I am looking for what was Slideco # 172543 that became Prime line G3069. Both are obsolete with them so wondering if you have a similar item.

Rusted part is connected to balance Plastic part is lock

Need to order 2 of these, 1 1/4 inch wheel, 2 1/4 long, 1 1/2 high, 7/8 wide

HelloHave some older ones here. Lost a small part you can see in another picture. Do you have any replacements. ThanksDave

Hi. I need help finding a replacement sliding glass door handle. Chrome trim is going to be painted white so if you have something in white that would be good. Thank you.

Looking for replacement latches for an old church. Latch handle number is 04-13921. Please advise if you have any information or replacement parts. Thx

I need 2 left and 2 right crank screw screw out. #on are r30842 and #40471 on main base Let me know what else you need. Thanks Chris

I am looking to replace my sliding door handle with lock. The handle crack on the outside pull. The screws are 3" 15/16 apart. The door is 1" 15/16 thick. There are no markings.

Hi, Im trying to repair some casement windows that the bottom style of the sash has rotted and some of the pieces have rusted out, and some seem to be missing. The crank mechanism is an EntryGard 20810. I have a left, and a right casement on this window. Can you help me identify the bad and missi ... (cont.)

I need to replace a Wright Awning window actuator can you help me out. If there is any other information need I will send.I need to replace 3 of them ThanksRandy

Looking to purchase two Pozzi Window Casement Cranks...one for a window on the right side and one for a window on the left side. Do you have them available or know where I can buy them??