Viewing all customer Discussions for:

Door & Window

I am having a hard time figuring out what replacement part best matches the pictures.

Hello, I was trying to confirm the Rivot size needed for part 15-272. Thank you!

2440 stamped on rod

It seams like the slpine my be broken on this operator. If I understand correctly the entire operator needs to be replaced. Can you help me idenfity the part? I will also need a cover. Thx

If you have questions and would like to talk to me, feel free to give me a call. I am on the phone from 4:30 in the morning till about seven at night. You can reach me at 218-838-7743 and Rodney Baker Thank you

Can you supply a replacement CMC-6 Balancer for a Midgard vinyl window with sliding/tilting bottom sash? Please see the included photos. The metal Chanel is 26 1/8" long, 5/8" wide, and 1/2" deep.

Hh

These are supporting hallway laundry access folding doors. Hinges are surface mounted with offsetting holes. Hinges are tricky and exact replacements are preferable.

I have an older sliding glass door that needs new wheels. I am attaching pictures so you can help me figure out what I need for replacements. I have not found any markings on the panels or frame as of right now.

the widest part at the corner is a half inch thick by a half inch wide and tapers down both ways to about 7/16 x 7/16 it does have a small tab on one side to go into a guide inside the screen frame. Pencil pointing towards this tab in photo.

I've purchased these clips from you previously, but can't find them on your site. Do you still sell them? I need 12. Thank YouFranklin

Could we please purchase 2 of these sliding glass patio door rollers? Thank you

Hello I have been looking high and low for replacements for the correct tandem wheel sets on the door that I have attached a picture of the model info below. This particular model comes with a 10/32 mounting hole and I have been unsuccessful finding that size mounting hole. I believe the wheel size ... (cont.)

3" screw spread, has the word "security" on the outside handle above key slot.

I need left and right sliding sash latches they hold the top of the window into the sliding track they are left and right handed they are 1/2" wide, total length extended is 4-7/8", mount Dist 2-7/8", 5/16" deep cannot find manufacture name but i think i found a date code of 1994 ... (cont.)

do you have these shoes? Also, the balances are 28c N BSI stamped. 9/16" wide. I think they are 770's? I don't have sash stops and think i will need to cut away part of the rail to get them out. At the top of the window channel? Thank you for your help. James

Looking to replace hardware. Not locking

Looking to find casement locking mechanism with the 4 holes for screws.

small plastic wedge with a small pin to snap into window. the wedge holds the window into the slide moving up and down. 1 on each side of the window

I had to remove this channel cover because landscaper knocked the track of of the stucco opening. It is an aluminum piece, and I bent it taking it off. I would be happy to replace it with plastic.