Viewing all customer Discussions for:

Door & Window

Looking for parts for these old single pane windows. The bottom locks are @ 4" long x 1/2" wide. The white corner clips are @ 1 1/2" long x 1/4".

Need replacement for the right side as attached.

I'd like to find the whole window panel but you don't seem to sell those. A few pieces that held the window in had broken and the window fell out of the door, getting bent on one corner. I am attempting to bend it closely enough back into shape and replace this white part, 2 springs and one of the l ... (cont.)

Need replacement of the photo above. Please advise of part #.

Are these available still? Is there a replacement folding style? Thanks!

Please see the attached photos. I think I need the rollers for an older Andersen sliding door. Can you please confirm the appropriate part number?

Hi I am looking to get a replacement valance for my jeld wen tilt windows. They have the rope hook attachment and also have the 1 inch green t lock balance closed cam. I believe your 795 series is what I need but with the smaller cam and rope hook. The stamp on the valances is 24B and 26 B. Is it po ... (cont.)

Hello, I am trying to identify this window operator. I believe it might be Amesbury Truth. The number on the back is 062905 0813M. Thank you.

When you open the window the window slams closed.

could you help me with identifying these parts that i need to order for my windows

I misplaced the Keeper for tmy kitchen sliding door. The house was built in 2005 and the sliding door is original equipment. I need the keeper to lock the slider. Thanks

I need help identifying the tilt in latch. It is mounted in the window, not a surface mount. Please help.

Casement

Hi folks, are you able to help identify which hinge is needed? Andersons' site has a bunch of different ones... although i have a measurement of one part of the arm...I think the main part is 10" (if I remember what I measured)

I need replace ment balances . They are 24" long, 1/2 in.wide. The markings are not great ( see pic), but say Caldwell and what looks like 23 2? D

Hi, I was hoping you could help me identify the part # for these (CALDWELL) parts for PGT window there are 2 different ones. I have bought replacement parts from Swisco in the past and they work great!

I'm looking replacement latches. I think they are surface latch replacements about 31/3 inches in length with screw holes (philips head) on both ends.

Hello, I am unable to find a rear backet that will hold up the drawer guide.

Looking to replace casement window lock old unit from 1960s. Can't find one with the 4 holes.

Hi looking for replacemenets or i will retro fit a standard bar BUT this one insert lenghth is un usual.... its 3/4 long any idea on a replacement that will match Thank you great resource