Viewing all customer Discussions for:

Door & Window

Im looking for 3" with screws at the 1" from each end I would then also need the springs and tool to release them tnx much

Trying to figure out which part i need to order for my kitchen windows to open them.

Looking for a replacement or something close for this

I'm looking for this part. It holds the screen in. We believe they are sunrise windows..

White window sweep lock with 2-1/4, the distinguishing detail on it is the tangs that center it over the strike

Screen door lock older

The cylinder is not engaging so the crank doesn't open the window. The arms are working. The Caradco cover needs replacement too.

Broken plastic piece

Hello! I have one that needs to have balances replaced, the size of the sash is 30x30 in, 2 tapes, the total height of the shoes is 4 in, the width is 1 in, please help me choose the necessary parts They also have the marking Pat. 5.5353.548 Thank you!

Not sure which window series to select. 1/2 in wide, length 28in. Non tilt window, see photos. Thanks

Can't find this slider door latch with locking rod attached

Hello, I am looking to replace a single arm casement window operator. The original was manufactured by Truth. I believe that it is about 7.5" - see the attached photos to determine exact length.Thank you in advance for your help.Stephen

Hello, Have recevied a replacement constant force spring from another supplier and for some reason- it will not fit onto the round white plastic wheel. It is the same #lb weight and type of spring. Any ideas?

I need to replace my bottom rollers on my silding glass doors....they are marked "ppg herculite k ansi z 97.1 - 1971 3/16"-u' . Please find the enclosed photo . What roller replacement do I need? Thank you JDR

I need two window latches. This is a window in my front door that opens along a hinge on one side. I sent several pictures. I don't know the brand of the door. The screws that hold the latch to the window are 2.25" spacing.

Seems to to stuck and hard to close or doesn't fully go up

Hello. I'm trying to identify the channel balance replacements for our non-tilt window. The metal channels measure approximately 24.75" long and are 9/16" wide. They are stamped with 24 2 notation.

Need to replace rollers for old metal sliding windows in mountain condothank you

I need the proper pivot bar and carrier for sliver line tilt in windows

Doletta Baltic doors/windows