Viewing all customer Discussions for:

Door & Window

The latch to lock the door broke off. Can you help me get what I need? The print on the glass was very hard to read but it looked like: GUARDIAN DEWITT IA ANSI Z97 1-1684 (could be 1-1884 or other) Safety tempered SGCC 2020 1/8 US 16 CFR 120I ii

Needing this type of glaze beading for an older style Aluminum frame window

We have an older condo with a large sliding glass door and the rollers are shot. I will also need weatherstripping for the seam between the two closed Panels and the perimeter top and bottom too stop small rattling noises. Here are the pics of one of the rollers...it's connected to the bottom rail w ... (cont.)

I have two (2) sliding glass doors . They were made by CFA Window Group. Spec. 48 PSF. They are over all 6'wide, in 04/99. I am looking to find the plastic trim on the outside.

Original latch on sliding door will no longer stay in locked position. Need a replacement. Please help.

Hello, Do you carry this specific window latch? Thank you, Roy

Hi Can you help me find this cover Thanks

How long is the pile on the weatherstripping on this face plate? It doesn't say in the product description. We will likely need somewhere around 3/8 and just want to know if we need to order some other pile in order to replace the one that comes with the face plate. Thanks!

It's a coil balance for a single hung MI window that's probably 10 years old or so. The stamped markings are difficult to read but I'm almost positive they read "932." I haven't found that marking on any replacement parts. Any help would be greatly appreciated. Thank you. Nate

24 inches length, 9/16. Stamped #2340 backwards E B.S.I. Would like to know if B.S.I is interchangeable with your brand

Hello, I am looking to replace window balances. The numbers on the metal coils are different though. 1 coil says 5IA and 1 says 7IA. can you help me identify what parts I need to replace these? thanks so much! :)

Hello I have Lawson SH-7500 aluminum single hung windows. I am needing new top sash guides for them and measurements are as follows: 1/2

rod length is 29" Stamped on rod 28B USB I am sure I have the correct rod length but I am unable to determine the correct ends for the rod. Looking at the pictures online they all look very close. Can you determine what is needed based on the pictures attached. If not, tell me what you would n ... (cont.)

This is from a Kolbe and Kolbe casement window. Do you have an operator that would work?

See attached picture can you verify what I need to order to fix my window. The clip that holds the slide is broken and I want to order more white locks shown in picture.

I ordered a 82-043. Completely wrong and to big. Please help me with finding the right part

30x30 1/4 bottom window with a 28" metal thing ? im missing the metal lead looking things that r screwed in on one sidepic i think it locks the window in place and im missing the 28" metal thing and the plastic thing pic. sorry i dont know the names the window is aluminum from 2000 aproximately g ... (cont.)

I am looking for replacements. The cardboard "T" was cutoff to try some rollers I bought. It needs to be there. The roller material is steel, diameter 1.25, width 5/16, roller housing height 1", roller edge concave, housing width 3/4", overall width 7/8", roller housing length 2-1/4". ... (cont.)

I sent a request in last week and have not head back. Screw center is 3

I've searched the Internet to include the Swisco part pages and am unable to find the two pieces in the attached photo. The storm windows on my house may be original to the 1973 house and one metal latch and many plastic tabs have broken. The plastic tabs are about 1" long. An intact one is s ... (cont.)