Viewing all customer Discussions for:

Door & Window

I need two of the attached operator assemblys for casement windows. One right hand swing and one left hand swing. I also need two sets of 10" casement hinges. What I am replacing is the Truth Hardware HInges. Does the Swisco hinges directly bolt in the same screw holes as the TRuth? ... (cont.)

Sash window lock . 1 5/8" hole spacing . Ordered some others from you but lock part is thick . Any help would be appreciated.

Hello, I am looking to replace the roller assembly for two doors, for assembly pieces.My name is Marie, from Coral Nay Management

Hi there, It appears that your company have a PhD in window balancers. Could you please help me identify which balancers/parts I need to order? I have two sizes (11.2 and 23.3), all images attached. Thank you kindly,Alex.

unique 45-F-60

tilt latch and pivot bar to replace

I have two large Andersen windows. The upper sash is (H) 3 95/8 x 32 3/4. The lower sash is (H)27 x 32 3/4. They are at leasr 26 years old, probably more. I need to replace the balances. They are 6.5 x 3 x 3/4. All the is legible is the No. 11600 on the balance.What do I need? Thanks, Ron ... (cont.)

Need both handle sides, tumbler housing and connecting linkage

Broke off my tilt in window. 5/8" between screw holes. Width is 7/16. 1-1/2" in length.

It looks like the knob to lock this patio door lock has broken off. Do you have any solutions? This is an older home, 1980's, not sure if this an original door.

Crank

Hi. I'm looking for an Andersen balance # J42 511 4 88.

Please help me identify this part. Crack in the spring for the balance went up through the top of the window frame.

Need three replacements of this part because the bottom part of the piece (where the window is supposed to be held) is cracked.

Hello, can you identify the manufacturer of my windows please? The house was built in 1988, the window frames are aluminum, are dark brown, uses spiral balances, and uses these little slip-in plastic blocks for sash alignment. Also do you know the p/n for these blocks and if they are available any ... (cont.)

Trying to find replacement door rollers. Please help

Hello, I need help identifying these window lever locks. I need four of them.

I could not find that shape

The parts are all within fractions and I think these measure as 2" high x 1 to 1 1/4 wide x 9/16 or 1/2 depth.

This goes into the window so I can install it and close it shut. One on each side. So I need two