Viewing all customer Discussions for:

Closet

Need the bottom pin with spring. Broke while removing. About 15 years old. See photos

Looking to replace this piece

i couldnt find any details or style numbers, I just have the photo attached the wheels are about one inch wide. One wheel is there one isnt. please let me know thankyou!

Hi, My name is Marie & I'm a home owner & interior designer. One of my mirror door rollers broke yesterday, and I'd like to order the replacement.US PAT 4850145 THMPlease let me know the ordering procedure.Thanks so much!Marie

Anything compatible? Disregard the screws showing on top I jammed them in to try to force the pin to stay locked.

It?s for a mirrored closet door

Looking for closet door rollers, ACME brand, there is a letter "2".

I have replaced a top guide spring-pin on my Benchmark bifold door by pulling the top and bottom guide pins on the end panel so it swings off the track, but how can I replace the bottom guide pin? There isn't much clearance from the carpet below. Must I lift the entire door off and lay it flat to ... (cont.)

Stanley coset door tracks - double track aluminum 10-15 yrs old, i need two 6 foot tracks,.

Hi, We're looking for replacement parts for mirrored closet door upper track guide. We've been hunting everywhere on the internet and finally was told that it has been discontinued. So our plan B is to replace the upper track and the guides. Could you check if your 23-245 and 23-222B will work? My m ... (cont.)

Not sure what I need. Some of the bottom pins and plastic guides that go in the floor track are missing, and one of the pins and guides for the top track is missing. 1974 vintage.

I have the rack in picture for my mirror closet doors. I want to replace it but I need help choosing the right one. Please can someone take a look at the picture and recommend which one to choose . The length is 48. Thanks . Loretta Agwuncha

I need : bottom truck for pair of closet glass doors made by Crest door company, Vancouver Doors are bronze frame and heavy. 1 inch thick. The upper truck too.

I need the track the mirror doors roll on 02013003

Hello, I am looking for the parts for my Mirror closet door. Attached is the picture. Could you let me know if you sell them? If not, can you recommend parts that I could replace with? Thanks Susanna

We need the above parts for the mirror doors along with instructions on how to remove and install them. Doors were purchased from Home Depot in 2006/07??? Thank you much.

We have a room in our 1940s home that has a closet running the width of the room, accessed by a pocket door on each end. The track is behind the wall, and because of the construction, we would have to remove trim on both front wall and inside closet, plus remove all the frame around the door in orde ... (cont.)

the part I need is the little nylon cap on the right end. The diameter of the wider end is 1/2 inch and the diameter of the hole for the pin is 1/4 inch. Pls let me know if you need anything more.

Hi, I need a Stanley 4212 because it is broken. Can You help me? Jan-Olof SVENSSON Korallvägen 2 SE- 554 54 Jönköping Sweden Or is there a shop I can contact here in Sweden, Jönköping?

Hello, I have ordered from you before and I have 2 sets of sliding doors that have this white plastic piece which has a "lip" at the bottom that insert into the floor track so doors can glide open/close. This "lip" on the white plastic broke (when pressure was applied to the door) and now the door ... (cont.)