Viewing all customer Discussions for:

Closet

I'm looking for 10 rollers as seen in image 3706/3711. I also am looking for 4 rollers seen in 3710. These rollers are 50 years old. Replacement parts would work just as well I'm sure.

Hello, I was looking for a guide to a Stanley Monarch closet door set--50304941 247335 are the numbers on the back of the door. Two sliding glass doors, each approximately 48" X 72" Height. Don't know if a part is needed as they slide ok but the one side has come away from the mirror. I can reglue t ... (cont.)

This number appears in red ink on the paper Stanley/Monarch label on the back of the door: 51003962 243514 Need to replace the bottom round disk that rides on bottom rail and allows the door to open and close. It measures 11/16 across. The number 5 shows inside the plastic where the door sp ... (cont.)

Greetings, I have a pocket door located in my kids bathroom. The unit appears to be a pre-fabricated Cox type unit but the previous owners never installed the door. The door opening is 23-1/4" with the jams. Outside width of the track itself, is 1 inch. Do you know what trolley might be a good fit ... (cont.)

I need to know what kind track and roller for a Monarch Mirror closet door to order.It is a sliding door. 48inch track is needed.

I believe it's a roller on the bottom track on moving door of mirrored bifold door.

I have by pass mirror doors. I need to replace the bottom track. This is 60 inch long. can you tell me what track I need. The one I have is white metal Thank you Nancy

I need to replace 2 of these rollers. I have sent a pic of the closet door info.

I have a closet opening of 10' 10" and I need to replace my track. What is the best way to place 2 pieces of your track (23-242) down without having the door catch at the seam?

Please see attached, I checked 23-086, 23-028, 23-070, 23-081, 23-064, and I cant find a perfect match to the rollers I have. I need to buy 8 rollers that look like the photo attached. The measurements are 1 1/4 inch wheel diameter (white part of the wheel edge to edge, 1 7/16 inch apart verticall ... (cont.)

What is best method to installover concrete? Is there a clip available for the track to snap into so no screw heads are visible? I'm looking for a way to keep the front and back edges of the track firmly attached to the floor.

Sliding door wheel

Can you please tell me what roller it is that I need to replace this roller? I need a link so I can purchase it. Thank you.

I have an older track and I have trouble opening the closet door all the time. I am looking into getting a new track for it. I have attached what the current one looks like.

Looking for parts. Can you recognize these and are they available? Thank you, Lyn

Need help identifying these bearings. They are shot. There are no company names on the door or the individual parts themselves. Any ideas?

Need two each replacement wheels for sliding Mirror wardrobe door set, can you identify the part on the attached photograph On the back of the door was a sticker with the following information: Guardian Industries, Reedly, CA, 16 CFR 1201 11, and SGCC 2117 1/8U

I have a metal frame mirror sliding closet door and the roller is bad. I don?t see any screws to remove the old one. What's the trick to getting it out?

I think it says RM=G1005? Missing several so mirror is sliding down out of frames.

Am I correct in thinking that the 21-058 pins go on both the top and bottom of the door, including the springs? The doors I'm working on are missing the hardware.(the pivot pins are ok) Also, am I going to have to remove the tracks from the floor and top of closet in order to slide the caps in from ... (cont.)