Viewing all customer Discussions for:

Closet

I have replaced a top guide spring-pin on my Benchmark bifold door by pulling the top and bottom guide pins on the end panel so it swings off the track, but how can I replace the bottom guide pin? There isn't much clearance from the carpet below. Must I lift the entire door off and lay it flat to ... (cont.)

Stanley coset door tracks - double track aluminum 10-15 yrs old, i need two 6 foot tracks,.

Hi, We're looking for replacement parts for mirrored closet door upper track guide. We've been hunting everywhere on the internet and finally was told that it has been discontinued. So our plan B is to replace the upper track and the guides. Could you check if your 23-245 and 23-222B will work? My m ... (cont.)

Not sure what I need. Some of the bottom pins and plastic guides that go in the floor track are missing, and one of the pins and guides for the top track is missing. 1974 vintage.

I have the rack in picture for my mirror closet doors. I want to replace it but I need help choosing the right one. Please can someone take a look at the picture and recommend which one to choose . The length is 48. Thanks . Loretta Agwuncha

I need : bottom truck for pair of closet glass doors made by Crest door company, Vancouver Doors are bronze frame and heavy. 1 inch thick. The upper truck too.

I need the track the mirror doors roll on 02013003

Hello, I am looking for the parts for my Mirror closet door. Attached is the picture. Could you let me know if you sell them? If not, can you recommend parts that I could replace with? Thanks Susanna

We need the above parts for the mirror doors along with instructions on how to remove and install them. Doors were purchased from Home Depot in 2006/07??? Thank you much.

We have a room in our 1940s home that has a closet running the width of the room, accessed by a pocket door on each end. The track is behind the wall, and because of the construction, we would have to remove trim on both front wall and inside closet, plus remove all the frame around the door in orde ... (cont.)

the part I need is the little nylon cap on the right end. The diameter of the wider end is 1/2 inch and the diameter of the hole for the pin is 1/4 inch. Pls let me know if you need anything more.

Hi, I need a Stanley 4212 because it is broken. Can You help me? Jan-Olof SVENSSON Korallvägen 2 SE- 554 54 Jönköping Sweden Or is there a shop I can contact here in Sweden, Jönköping?

Hello, I have ordered from you before and I have 2 sets of sliding doors that have this white plastic piece which has a "lip" at the bottom that insert into the floor track so doors can glide open/close. This "lip" on the white plastic broke (when pressure was applied to the door) and now the door ... (cont.)

I'm looking for 10 rollers as seen in image 3706/3711. I also am looking for 4 rollers seen in 3710. These rollers are 50 years old. Replacement parts would work just as well I'm sure.

Hello, I was looking for a guide to a Stanley Monarch closet door set--50304941 247335 are the numbers on the back of the door. Two sliding glass doors, each approximately 48" X 72" Height. Don't know if a part is needed as they slide ok but the one side has come away from the mirror. I can reglue t ... (cont.)

This number appears in red ink on the paper Stanley/Monarch label on the back of the door: 51003962 243514 Need to replace the bottom round disk that rides on bottom rail and allows the door to open and close. It measures 11/16 across. The number 5 shows inside the plastic where the door sp ... (cont.)

Greetings, I have a pocket door located in my kids bathroom. The unit appears to be a pre-fabricated Cox type unit but the previous owners never installed the door. The door opening is 23-1/4" with the jams. Outside width of the track itself, is 1 inch. Do you know what trolley might be a good fit ... (cont.)

I need to know what kind track and roller for a Monarch Mirror closet door to order.It is a sliding door. 48inch track is needed.

I believe it's a roller on the bottom track on moving door of mirrored bifold door.

I have by pass mirror doors. I need to replace the bottom track. This is 60 inch long. can you tell me what track I need. The one I have is white metal Thank you Nancy