Viewing all customer Discussions for:

Closet

This is different roller not the 23-041. We also need 48" of track

Am trying to find instructions for how to use the "adjustment screw." Turning the screw is difficult & it is unclear that it even has any effect. Need very basic info on what "adjustments (e.g., direction?; distance?)" can be made with the adjustment screw, does the door have to be removed from the ... (cont.)

one of the doors keeps coming off the bottom track. do you sell anything that looks like this? thank you

I need a replacement track because the original wood track was destroyed during a renovation. The opening is 36 1/4 inches wide, with a pair of metal bifold doors that install in the opening. The doors appear to be original to the house, which was built in 1961. Each bifold door is 17 3/8 wide X ... (cont.)

bi-fold door guide caps

I am looking for the bottom track for a sliding bypass mirrored closet door that is at least 15 years old and made by Stanley. Attached are photos of the top and bottom rollers, but I am not sure which is which at this point. I think what I need is 23-242. Should I also buy replacement bottom roller ... (cont.)

We have a set of 3 mirrored closet doors that are 96" high. The wheel assemble on one is broken. The mirrors are metal framed and we do not know how to replace the wheel.

Hello, I purchased this door hinge based on the recommendation of your website. However, it does not fit/attach to my sliding mirror. Please advise... This is located in a home built in the late 1970's. Very likely original to tas not many updates have been done to the unit.

I am trying to fine the correct pins for a Flow Away ,steel ,mirrored ,bi fold closet door. The doors have two different types of pin holders. Most of the doors that work have white plastic bushings at the top an bottom of the steel door with some kind of black plastic for adjusting. These seem f ... (cont.)

Hello. Can you help me identify the proper track to purchase for these closet doors ?The opening is 48" . The original tracks were thrown out . These doors are in a mobile home (estimated built in the late 70's . ) Doors are in good shape as well as the hardware .

Hello, I'm considering the following: 8 hollow 17" doors - Can these doors be set-up as bifolds. What are the parts I need to order? I imagine inserting the hardware in the tops & bottoms and sides very time consuming, but it would be sturdier than the mirror bifolds.

I need two metal of picture roller

I just ordered a 21-092 pivot and two 23-120 top rollers. I see no reference to bottom rollers. Top rollers had been installed at the bottom but they failed. What should I order?

On the back it says 1 3/8 front and 3/4 rear.

Please help me identify these parts, thank you

Can you tell me what style this is? Mary Anne

We need new tracks and possibly new pins for this metal bifold door 24x89

I need two door roller preferably in metal because platic not resit the door heavyweights

I am searching for a comparable match to this wardrobe sliding door roller. The roller's markings are: "Roll Master", EZ Roll HDWR MFG CO., Westbury, LI, NY. The offset is 1 1/2

I've seen this part, but i'm not entirely sure if i need to order though stanely or can i get it someplace else.