Viewing all customer Discussions for:

Closet

CAn I use part # 21-007 21-001 21-155 To replace in the photo attached

I have a mirrored bi fold door that is somewhat difficult to open. It had a 10-008 stuck on as the pull, but it broke off recently at the handle. I wondering if the larger 10-010 would be more secure since it has more adhesive contact and larger handle?

Hi, Do you offer a 126" sliding mirror door bottom track for 3-doors? I currently have the 3 doors on a 2-door track, but I want to improve the access with a 3-door track. If you do not offer this track, do you have any ideas for me? Thanks Michelle

I want to make a 72 inch closet have 3 (24 in) mirror doors instead of just 2. It makes it easier to reach the center of the closet. Do you have any bottom and upper track/guides that I can use? I found (3) 2-foot mirror doors that have concave roller's on bottom and standard plastic roller/guides ... (cont.)

Replacement tracts

Existing unit is 48-50mm wide by 75mm tall. The wheel is plastic/nylon 32mm diameter. The doors are full height floor to ceiling and weigh about 40kgs each.

Need to replace roller Can you suggest the correct part Thanks

I need 1/4 inch nylinders 2 pieces 21-150. Also need pin caps 4 pieces 21-108. I also have bumpers that are 7/16 inch by 1 1/2inches in lenght

Hello, I recently purchased 4 of the Mirror Wardrobe Door Roller items (your product number is 23-070) because your website said they were compatible with the COX item 21-717, 21-767. The problem is that the wheel is concave in the center and the wheels I need to replace are convex, the actually pr ... (cont.)

The plastic cracked on the bottom of the slider and I need to replace some ..whether it be with the plastic roller or a metal one But it needs to have the support flaps on the bottom to reach underneath and hold the glass within it I have the screw holes only on the bottom and on the left sid ... (cont.)

These are closet door hanger rollers marked with the letter A.

I recently ordered 23-270 roller track but was not the product I was looking for. I am going to attach some photos and wanted to know if you could recommend another product for me?

The plastic part holding the wheel in broke off. If I need to replace the whole piece, how do I get it off the door? It is not screwed on, just held in place by all the metal prongs. I can't figure out how to remove it to replace it.

Track is mangled. 6 foot closet, mirrored oak trim. All but trsck in great shae. Help!! Also included pics of rollers which are fine.

looking to replace the bottom track for double mirrored closet doors. It is gold-tone. It measures 58&1/2 in. long X 3 in. wide. Someone at Home Depot wrote Stanley/Masunite, don't know what that means, but they gave me your website. Sure hope you can help. I will also need new wheels, right? ... (cont.)

Looking for this roller or suitable alternative.

Good morning I need new tracks for bifold doors from the 1970s. the opening is 48 inches. I need the upper and lower track. I hope the pictures help.

I ordered a few parts, the cam and I didn't want to install them immediately. When I finally did, I found out that they were wrong. I can send you the a picture of the correct and incorrect part for a little help figuring out just what I need. The silver ones are the ones that I previously ordered ... (cont.)

I am replacing my bifold doors with new doors and the track that is currently there is larger than is compatible with the doors that I am going to install. I need a track that will fit a 7/16 size pin, but there is not a width listed on these tracks. Are your 23-250 the correct tracks for my doors? ... (cont.)

I need to buy the bottom and top tracks for the sliding mirror doors.