Viewing all customer Discussions for:

Closet

We have a set of 3 mirrored closet doors that are 96" high. The wheel assemble on one is broken. The mirrors are metal framed and we do not know how to replace the wheel.

Hello, I purchased this door hinge based on the recommendation of your website. However, it does not fit/attach to my sliding mirror. Please advise... This is located in a home built in the late 1970's. Very likely original to tas not many updates have been done to the unit.

I am trying to fine the correct pins for a Flow Away ,steel ,mirrored ,bi fold closet door. The doors have two different types of pin holders. Most of the doors that work have white plastic bushings at the top an bottom of the steel door with some kind of black plastic for adjusting. These seem f ... (cont.)

Hello. Can you help me identify the proper track to purchase for these closet doors ?The opening is 48" . The original tracks were thrown out . These doors are in a mobile home (estimated built in the late 70's . ) Doors are in good shape as well as the hardware .

Hello, I'm considering the following: 8 hollow 17" doors - Can these doors be set-up as bifolds. What are the parts I need to order? I imagine inserting the hardware in the tops & bottoms and sides very time consuming, but it would be sturdier than the mirror bifolds.

I need two metal of picture roller

I just ordered a 21-092 pivot and two 23-120 top rollers. I see no reference to bottom rollers. Top rollers had been installed at the bottom but they failed. What should I order?

On the back it says 1 3/8 front and 3/4 rear.

Please help me identify these parts, thank you

Can you tell me what style this is? Mary Anne

We need new tracks and possibly new pins for this metal bifold door 24x89

I need two door roller preferably in metal because platic not resit the door heavyweights

I am searching for a comparable match to this wardrobe sliding door roller. The roller's markings are: "Roll Master", EZ Roll HDWR MFG CO., Westbury, LI, NY. The offset is 1 1/2

I've seen this part, but i'm not entirely sure if i need to order though stanely or can i get it someplace else.

CAn I use part # 21-007 21-001 21-155 To replace in the photo attached

I have a mirrored bi fold door that is somewhat difficult to open. It had a 10-008 stuck on as the pull, but it broke off recently at the handle. I wondering if the larger 10-010 would be more secure since it has more adhesive contact and larger handle?

Hi, Do you offer a 126" sliding mirror door bottom track for 3-doors? I currently have the 3 doors on a 2-door track, but I want to improve the access with a 3-door track. If you do not offer this track, do you have any ideas for me? Thanks Michelle

I want to make a 72 inch closet have 3 (24 in) mirror doors instead of just 2. It makes it easier to reach the center of the closet. Do you have any bottom and upper track/guides that I can use? I found (3) 2-foot mirror doors that have concave roller's on bottom and standard plastic roller/guides ... (cont.)

Replacement tracts

Existing unit is 48-50mm wide by 75mm tall. The wheel is plastic/nylon 32mm diameter. The doors are full height floor to ceiling and weigh about 40kgs each.