Viewing all customer Discussions for:

Closet

I have a pocket door in my downstairs bathroom that needs the 4 wheel pocket door rollers replaced. Each roller is 3 in long and 1 in wide. Will the product shown above work as the replacements? Product code 23-193

I have 3 sliding doors approx 7'8"x3'4", very heavy closet mirror sliding doors... about 20 yrs old and all off the track because the hardware wheels have broken. Can you provide replacements?

Please recommend a replacement part

I have DSH20121 hardware on my doors. We removed the doors and track to put in a new floor and now I can't get the hardware to go into the track. I'm sure it's pretty simple but I'm not getting it. Can you please advise how to install the hardware into the floor track.

I have two bifold doors Each measure 29 1/2" when opened Do you have a hardware kit to hange both in one opening What is the recommended finished opening for these doors

Hello, I'm wondering if I need both bottom and top tracks for the mirror closet doors. The floor has been raised a good inch due to new floors and would like to reinstall the mirror doors using the same h/w but without the bottom track and just a pivot mount on the bottom. if not, can you advi ... (cont.)

Is this the rcorrect replacement

We notice the white plastic wheels are cracked. We are looking for the replacement parts.

Hello - I am trying to find this roller or one that will work in it's place. I don't have any other information than the picture and don't have access to this hardware anymore to look at. It is made by Lawerence Brothers and states 3/4 rear and 1 3/8 front on the hardware and is a tandem roller. Any ... (cont.)

Hi! I am looking for a replacement cap that goes on the pin. I have more pictures if needed. Thanks Suzanne G

I need a complete set of the subject hardware

Please tell me which part to order to replace the closet door track. It is 3 and 3/4 wide and 105 inches long. thank you! Jicki

wondering how I install this part? am I ordering the metal bracket and plastic piece or just the plastic part?

Has DNS imprinted

Hi, I noticed that the sliding doors on my closet were coming off track at the bottom and I think its this piece that is broken, but I am not sure. If it is, what do I order? DHS 20121

How to push the roller down into the track. I screwed the vertical screw to the end but it still doesn't go into the track. Should l remove the whole thing and insert it at an angle like in the video. And install it back or there is another way to push it down after hanging the sliding mirror door ? ... (cont.)

I can't find and markings on my four closet doors or the hardware. Can you identify these?

I need to replace the Monarch mirror door track for three pieces, length are 2 for 67.5 inc, 1 for 47. 1/4,inch. Please See attached photo. I think should be model 23-241, but one of them seems like they squeeze it to be narrower. Is the photo show the products should be the same model? ... (cont.)

Looking for part info on this roller

so the height between the two black (not very straight) lines is 3/4"