Viewing all customer Discussions for:

Closet

Have 3 of these per door- are they a wear item? They seem slightly smaller (1/8") than the track and the door bangs around at the top. Thanks.

Why is the top piece that attached to the doorway plastic instead of brass? My other hardware on my old saloon doors has a top brass piece and not plastic. It looks a lot nicer especially when its on the top where people will most likely see it.

I need 2 replacement concave wheels for a large mirrored closet door . I've included photos you can see the brass part is bent I just need the 2 wheels the bracket part is fine thanks Karen

Please help find replacement part.

The entire unit is fine except the white plastic wheel broke

These parts are for a Contractor's Wardrobe mirrored sliding door. The plastic piece has part #RM-G1005. The metal bracket does not have a part number on it.

I need to replace this wheel, I sure hope you can help.

Door has label: Home Decor Innovators Safety Mirror. #64564-001 This part sits in channel on top frame of Door in which it glides back and forth to keep door upright. Please let me know if part can or cannot be found. Thanks so much!!!! Nancy

Bottom rail thanks bill

measures 1" square at the top 3.5" high

I have 2 sliding doors, made in 1955, which have wheels made by "Cox & Sons", Pasadena, CA. The 1" DIA wheels have NO ball-bearings and are badly worn-out, see 2 pix for dimensions. The spades are 1" wide. What are the right replacements WITH ball-bearings you can offer and at what cost, incl shipme ... (cont.)

The description for this part says it comes with a Pivot bracket. Doesn't it come with two since it needs one at both ends to function properly? I intend to use it for a dual panel bi fold mirrored closet door with a 48 inch opening. Thanks for any info...

I have a pocket door hanger/roller which needs replacing. It was probably put in on 1959. On the roller, it is printed with "Reu Boiu". Can someone point me in the direction? Thanks!

U.S. PAT 4850145 THM

Hey! Looking to replace a bi-pass Mirror Door closet bypass bottom mount track. It's 59" long and 3.25" wide. The two wheel tracks are about 0.5" with an 1" spacer track in between. Do you have anything that might work as a replacement? Thanks! Brindisi

HI, I have pocket doors that require new trolleys. Do you know of any straight replacement I can use? Any help would be greatly appreciated. Regards Peter

Hi, I am trying to replace these rollers. Your part number MIRROR DOOR ROLLER, 1-1/4" DIA. Product Code: 23-043 seems to be the best choice since the roller diameter and width is the same, as well as the casing thickness and tab offset/height. The casing is a bit different in design but very close ... (cont.)

Need complete set of hardware to hang. Top and bottom. Track requires tapered nylon guides to fit.

Hi. I'm looking for a replacement floor track for a Stanley Monarch Accent 220/Prism 320. This is a sliding mirror door. Door is installed in 6-foot wide opening. Part No. is 4144. Thank you.

Hi, I am disabled and live on a tight budget. Is it possible to just replace the concave wheel that is "riveted" on? Wheel is 1 1/2" and 1/4" wide. Rivet is 1/4" hole. If I can replace just wheel will you please tell me part number and a link or guide on how to replace wheel? I would be so very ... (cont.)