Viewing all customer Discussions for:

Closet

I need to replace this wheel, I sure hope you can help.

Door has label: Home Decor Innovators Safety Mirror. #64564-001 This part sits in channel on top frame of Door in which it glides back and forth to keep door upright. Please let me know if part can or cannot be found. Thanks so much!!!! Nancy

Bottom rail thanks bill

measures 1" square at the top 3.5" high

I have 2 sliding doors, made in 1955, which have wheels made by "Cox & Sons", Pasadena, CA. The 1" DIA wheels have NO ball-bearings and are badly worn-out, see 2 pix for dimensions. The spades are 1" wide. What are the right replacements WITH ball-bearings you can offer and at what cost, incl shipme ... (cont.)

The description for this part says it comes with a Pivot bracket. Doesn't it come with two since it needs one at both ends to function properly? I intend to use it for a dual panel bi fold mirrored closet door with a 48 inch opening. Thanks for any info...

I have a pocket door hanger/roller which needs replacing. It was probably put in on 1959. On the roller, it is printed with "Reu Boiu". Can someone point me in the direction? Thanks!

U.S. PAT 4850145 THM

Hey! Looking to replace a bi-pass Mirror Door closet bypass bottom mount track. It's 59" long and 3.25" wide. The two wheel tracks are about 0.5" with an 1" spacer track in between. Do you have anything that might work as a replacement? Thanks! Brindisi

HI, I have pocket doors that require new trolleys. Do you know of any straight replacement I can use? Any help would be greatly appreciated. Regards Peter

Hi, I am trying to replace these rollers. Your part number MIRROR DOOR ROLLER, 1-1/4" DIA. Product Code: 23-043 seems to be the best choice since the roller diameter and width is the same, as well as the casing thickness and tab offset/height. The casing is a bit different in design but very close ... (cont.)

Need complete set of hardware to hang. Top and bottom. Track requires tapered nylon guides to fit.

Hi. I'm looking for a replacement floor track for a Stanley Monarch Accent 220/Prism 320. This is a sliding mirror door. Door is installed in 6-foot wide opening. Part No. is 4144. Thank you.

Hi, I am disabled and live on a tight budget. Is it possible to just replace the concave wheel that is "riveted" on? Wheel is 1 1/2" and 1/4" wide. Rivet is 1/4" hole. If I can replace just wheel will you please tell me part number and a link or guide on how to replace wheel? I would be so very ... (cont.)

I have a pocket door in my downstairs bathroom that needs the 4 wheel pocket door rollers replaced. Each roller is 3 in long and 1 in wide. Will the product shown above work as the replacements? Product code 23-193

I have 3 sliding doors approx 7'8"x3'4", very heavy closet mirror sliding doors... about 20 yrs old and all off the track because the hardware wheels have broken. Can you provide replacements?

Please recommend a replacement part

I have DSH20121 hardware on my doors. We removed the doors and track to put in a new floor and now I can't get the hardware to go into the track. I'm sure it's pretty simple but I'm not getting it. Can you please advise how to install the hardware into the floor track.

I have two bifold doors Each measure 29 1/2" when opened Do you have a hardware kit to hange both in one opening What is the recommended finished opening for these doors

Hello, I'm wondering if I need both bottom and top tracks for the mirror closet doors. The floor has been raised a good inch due to new floors and would like to reinstall the mirror doors using the same h/w but without the bottom track and just a pivot mount on the bottom. if not, can you advi ... (cont.)