Viewing all customer Discussions for:

Closet

I need the little plastic disk, only one i need one pin that has spring as denoted in photos I need one adhesive square on square closet pull These are mirrored bi fold closet doors

Hi, I need to find a replacement for the part shown. Do you carry it or know where I can find it? Thanks, Shannon

I have an old Strato-fold door. It is a single bi-fold door measuring 36 x 96. Serial # 16808. I need the full set up of hanging hardware. Some of the parts are missing so it's hard to determine exactly what I need from your site. In looking at the schematic on the back side of the door, I ... (cont.)

there are two 5 foot double bipold door closets.they have both same tracks on top and bottom

Can you please tell me where I can purchase this part?

Can you help me identify and locate this roller?

Can you help me identify and locate this closet door part?

Please let me know if you could help me locate something as a replacement. Thank you.

Need this replacement roller for mirrored closet doors.

Agradecer

top mirror door runner assembly

This home is a "Warmington" built home finished in 2004. The track is so bent now that the door doesn't work. The total door width is 58 inches. Each door is 92 inches high and 30 inches wide. There is a small plastic piece at the bottom that supposedly keeps doors on. I've had problems sinc ... (cont.)

I am looking for a bottom guide pin. I need the entire part ( not sure Of there is more than one piece) for my benchmark bifold door

Hello, I am a DIY and building closet doors for six closets. I am planning to use 3/4 inch thick wood for my doors. Your tracks on your site are designed for 1&5/8 inch doors. I was wondering what tracks and other hardware you would recommend for 3/4 inch doors.

I have a pocket door that uses the 23-255 hardware. The door is out of alignment, with one end much lower than the other. How do I adjust it? I tried unlocking it and turning the little white plastic wheel, but nothing happens. There is no way to get a wrench up in there to physically adjust the ... (cont.)

I have a Stanley Mirrored sliding door Part number 64564-001. I need a bottom track for it. The measurements for the track based on how ya'll measure bottom tracks is 1 5/8 --- 3 5/8---47 Please help identify correct bottom track for purchase. Refer to photo included for reference. ... (cont.)

I have a pocket door with a wood track. The track has a 3/8th cut out. The wood track width is 1 1/2 in. With the 3/8th cut out and the top track is 1/2 in. Thick. The roller would need to fit on top of the wood track with a bolt drop down through the cut out and connect to the top of door brack. My ... (cont.)

Can you tell me the size rod this bracket will take. I need one that will take a 1/4" pivot rod. Thanks!

Hi, Any help on this is appreciated. I have attached pictures of the top and bottom pivots as well as the top/bottom guides along with their measurements. I would like to know if you have these parts available as well as the springs. These pieces came off metal bifold closet doors. Not sure of t ... (cont.)

Does anyone have this?