Viewing all customer Discussions for:

Closet

I believe I need the guide pins on my benchmark doors. The ones that are stationary are good, but the ones that slide on the track have no tension to stay in the track or didn't fully reach the track. I see the parts that I think I need, but how do they install on the door so that they pop into plac ... (cont.)

I ordered new tracks (left in photo) that did not fit. The original tracks are on the right, and I'm trying to match those. The length is 59".

Need replacement for corner cabinet hinge for door that extends out

One of the doors has a square roller that goes back-and-forth on the door. My other doors are missing that piece

I need to replace the same type of male THREADED ball catch and spring on my closet door. The male part (pictured) screws into the brass female catch inside the top of the closet door. The treading allows the ball to be adjusted so the closet door closes securely. I'm not sure the one you recommende ... (cont.)

Hello,Attached are door rollers I am trying to replace. As you can see, the plastic rollers are destroyed. Looking through your catalog, it looks like either 23-081 or 23-086. However, I cannot tell if mine is defined concave or convex??On another note, is it possible to pop out the plastic wheel ... (cont.)

Hello I'm just having a bit of trouble finding out what parts were used on this bifold door working on it for a home owner they didn't know how long ago it was on there Hope you guys can help me out if you even still make these parts or have something similar to them Thank you

First post

Hi , I am trying to replace hardware ( 3- pins pivots etc) to fix "one)leigh full view bifold door.

I'm looking for a soft close version of this hinge. can it be limited to swinging open 90 degrees?

Closet Folding doors top pivot cap

I have bifold doors but I have lost the top pinwheel that keeps the door on track along with the spring post. The track width can accommodate a pinhead of about 5/8 inch in diameter. The height of the wheel that is on the other door is about 1/2 inch. Looks like I am also missing the plate that a ... (cont.)

The top of the sliding glass door one of the wheels rubber part broke. Is there a way to replace it thank you.

This plastic piece fits on the top of the sliding glass door and I can't seem to find anything like it.

malfunctioning bottom part

I am looking for sluggers for older bifold closet doors. The track is 3/4" x 3/4" and the slide opening is only 3/8". I have included photos of both the double bifold and single one. I will need sluggers to fit both style doors. Thank you for the help. I appreciate the reply but I still can't determ ... (cont.)

I have this part with a broken piece of plastic as you can see. It's for a bifold closet door at the top, mounts to the door where the hinge would be. Is there a replacement part?

Hi. I'm renovating a house and the contractors lost two sliders for pocket door they were going to reinstall after renovations. I need two of these parts

I am looking for a replacement pivot guide for a large Bifold Mirror Closet Door. I think that the mirror was installed around 1974 in Summit County, Colorado. One of the doors opens and close just fine. The other guide wore out the plastic piece.