Viewing all customer Discussions for:

Closet

This goes in the top of a folding, sliding, closet door. It sits in a hole in the door and is held in a track. The top of the screw broke so it no longer stays in the sliding door track. The top part of the screw, rotates/rolls, horizontally, going forward and back in the sliding door track. Let me ... (cont.)

Hi Ron looking to rebuild how thanks.

My bi fold doors came out of the track. I'm trying to put it back together and am not quite sure how the plastic "slider" for the top and the "snugger" go together.

Hi there, The bottom track was unfortunately ripped out and disposed of with instillation of carpet. We don't have the old bottom track, but the upper track is still installed. The opening is 60", door is Slimfold from the 80s. Any help would be appreciated! Kathleen

I need the part that has the screw on the picture.The other part seems to be Part 23-042Would you help me to find it?

Can you help me identify what roller to buy? I need 4.roller is 1 1/4" in diameter.Thanks,Alan...

Hi, I'm looking to replace 2 of the parts shown in the picture (1 pair needed, 2 pieces total). The pieces are either the top track rollers, or the bottom track guides, for sliding closet doors that are commonly found in condos. These doors usually come in pairs of two, have a top roller track as we ... (cont.)

2 closet sets of hardware GLIDE ALL WEN 177-1 Thank you

I need replacement bottom hinges for Benchmark Steel Bi fold door

I=looking for a part: bottom pivot plastic only. This part stays in the track and leads the edge of the right right door. Thank you, I know they don't do this anymore.

Hanging roller bracket part #674. 3/4 front , 1 3/8 rear

Please give me part numbers so I can order 4 3/4" rear 1 3/8" front

Please help identify this part for purchase of a replacement

Hello, I am in need of a bottom concave roller track that is 104 inches long. Do you have this size available? Thank you Tim

Track is 3"x60" long with two track.

New house. Not sure what track I need for this I'm assuming it's a bottom track based on the wheels attached to it?

I need four replacement roller assemblies, and the bottom track that they roll in. I have the top guide track. I would like to know the replacent part numbers, if that is possible. THey are mirrored wardrobe doors that overlap slightly. The outside width of the mirrored sliding door frames is 7/8". ... (cont.)

Small grey slider has knob on one end goes into slider , 2 prongs at other end

Looking for a replacement part for this wardrobe door! Any tips appreciated for this DIY'er.

Hello, this is a 6ft bifold door opening. I have the mirrored doors but am missing the track.