Viewing all customer Discussions for:

Drawer & Cabinet

Need to replace this hinge

Here are some photos of my balance including a code of ( D V A 1) on the side of the 29" tube. The full length with the spiral Extended is 58". I am trying to determine the tip color and wanted to see if you agree this is a yellow tip. Please let me know.

Looking for a replacement for this hinge

My overall drawer length this 21 3/8 inches. Will this slide fit? The overall cabinet depth is 23 1/4

If I could find the connection part, that's all I need, but I'd buy the whole hinge if available. main: 698.254.50.00 connection: 348.253.00.72

23/5" from back of cabinet to opening for drawer in cabinet Bracket was attached in back of the cabinet and at side of drawer opening. There is a gap in cabinet so no where to screw in sides. Drawer as in pictures. Looking to remove old tracking and find a solution for new tracking for this silve ... (cont.)

It is a two part piece. The piece the rail goes into snaps into the piece mounted on the back.

This one split because I think the guide rail was a bit too "tall" and caused it to split so I would want one slightly higher top to bottom, but not sure that is possible.

Bathroom vanity drawer broke. Looking to replace the plastic backplate. It is part #295.621-01.22 >pa66The length of the bottom rail as shown is 17 5/8 inches. The length of the top rail that slides over it is 18 1/2 inches.

I'm thinking about removing the plastic from the original metal housing I have, and purchase the 32-081 and insert inside the original metal housing.Do you think this will work? Is the 32-081 plastic the same thickness 32-082? Thank you

looking for BLUM Tandem 510.500/03.02 drawer slides

Hello, I just tried to update the photos through the website by clicking on the red add photo button under replacement parts but was not allowing me to do so. We are having a challenge finding the attached hinge .. Serial number 674.228.53.01 made in Germany(slide 6 shows that metal cracked off bot ... (cont.)

What are they called so I can order some new ones

I was wondering whether you had anything to replace a mepla plastic drawer support. Piece is around 1 13/16" x 1" x 7/8". Thanks, ET

I'm attaching a picture with this statement I believe that my rear guide brackets may be glued on I do not see any screws how should I remove these

These are hinges installed in new cabinets acquired in 1986. The paperwork seems to describe them as "ACC 130" hinges from Mepla in High Point, NC.

Number 7 marking, drawers. Are plastic. Thanks

I'm wondering what part this might be.

Hello I am needing a replacement for the attached part. I measure it to be 4 inches from center.

You know where I can get the part 175L660-01.22 for hinge 70.550.01