Viewing all customer Discussions for:

Drawer & Cabinet

I'm thinking about removing the plastic from the original metal housing I have, and purchase the 32-081 and insert inside the original metal housing.Do you think this will work? Is the 32-081 plastic the same thickness 32-082? Thank you

looking for BLUM Tandem 510.500/03.02 drawer slides

Hello, I just tried to update the photos through the website by clicking on the red add photo button under replacement parts but was not allowing me to do so. We are having a challenge finding the attached hinge .. Serial number 674.228.53.01 made in Germany(slide 6 shows that metal cracked off bot ... (cont.)

What are they called so I can order some new ones

I was wondering whether you had anything to replace a mepla plastic drawer support. Piece is around 1 13/16" x 1" x 7/8". Thanks, ET

I'm attaching a picture with this statement I believe that my rear guide brackets may be glued on I do not see any screws how should I remove these

These are hinges installed in new cabinets acquired in 1986. The paperwork seems to describe them as "ACC 130" hinges from Mepla in High Point, NC.

Number 7 marking, drawers. Are plastic. Thanks

I'm wondering what part this might be.

Hello I am needing a replacement for the attached part. I measure it to be 4 inches from center.

You know where I can get the part 175L660-01.22 for hinge 70.550.01

Looking to replace two Mepla hinges 664 261 53 00 for a bifold lazy Susan door. I also need the plates that the hinge attached to. Help!

I need two replacement Aristokraft 09C-3 Cabinet door hinges. Can I get two?

Hi, I am looking for a replacement for a discontinued Scheirich part that others have asked about also (the one that mounted to a metal rail in the back of the cabinet). Am I correct that your 32-089 will accept a side rail that is exactly 1-inch wide? Thanks in advance!

I only need one. I'll send a picture.

Aristokraft

The chest is Lexington brand. Two handles broke into. I'm looking for replacements. Deborah

Does anyone have a drawer pull that is antique brass and the center is oak.The furniture co went out of business. The company was Furniture traditions manufacturer.Thanks Ingram

I need a set of knobs for my dresser

Do you stock thos