Viewing all customer Discussions for:

Drawer & Cabinet

I was wondering whether you had anything to replace a mepla plastic drawer support. Piece is around 1 13/16" x 1" x 7/8". Thanks, ET

I'm attaching a picture with this statement I believe that my rear guide brackets may be glued on I do not see any screws how should I remove these

These are hinges installed in new cabinets acquired in 1986. The paperwork seems to describe them as "ACC 130" hinges from Mepla in High Point, NC.

Number 7 marking, drawers. Are plastic. Thanks

I'm wondering what part this might be.

Hello I am needing a replacement for the attached part. I measure it to be 4 inches from center.

You know where I can get the part 175L660-01.22 for hinge 70.550.01

Looking to replace two Mepla hinges 664 261 53 00 for a bifold lazy Susan door. I also need the plates that the hinge attached to. Help!

I need two replacement Aristokraft 09C-3 Cabinet door hinges. Can I get two?

Hi, I am looking for a replacement for a discontinued Scheirich part that others have asked about also (the one that mounted to a metal rail in the back of the cabinet). Am I correct that your 32-089 will accept a side rail that is exactly 1-inch wide? Thanks in advance!

I only need one. I'll send a picture.

Aristokraft

The chest is Lexington brand. Two handles broke into. I'm looking for replacements. Deborah

Does anyone have a drawer pull that is antique brass and the center is oak.The furniture co went out of business. The company was Furniture traditions manufacturer.Thanks Ingram

I need a set of knobs for my dresser

Do you stock thos

I am looking for replacement hinges for my century furniture cabinet model 42a-425.

I am looking for this cabinet hinge. Patent number shows as 3,613,151 it is a partial wrap 3 holes for the door and 1 hole on the cabinet style.

holds guide where drawer slides in and out. 2 holes on top 1"c, with 3 holes 1 and 1/8apart on a flat back

A number of brass drawer pulls on my Officers' Chest Collection" / "Campaign collection" have worn so that they don't work well and cannot be put back in their "slots" as the pegs have worn down over the years. I have been told that Henredon is no longer in business, but is there a way to order ne ... (cont.)