Viewing all customer Discussions for:

Drawer & Cabinet

I need to replace a few pulls for Drexel Heritage European Retreat dresser

Do you have this part that is broken on the wall, so the drawer can be put back in?

I see this handle has 2 1/2 inch centers, but what is the overall width and height of the handle?

Previous message included a typo in my email address. I am looking for a replacement for this part, which screws into the bottom of a dresser drawer and clips into the side mounted slide rails. Thank you, Cynthia

Old Merrilot back bracket on sliding drawers have finally worn out. What can I replace them with and still use the original rails (floating).

I need some of these under mount drawer slide hanging brackets. The slides are from the manufacturer Grass. But they said the hanging brackets are not from them.

Hi, I am looking to replace Grass USA Side Mount Slide Rollers. Looking for 570mm. The model number from Grass is 01225-09 (left) and 01248-09 (right). I need 4 sets. Can you make a recommendation? Thanks Tim

HAVING A PROBLEM LOCATING RIGHT REAR DOOR GLIDE . I PURCHSED SOME 32-122'S TO BIG THEN BOUGHT SOME 32-030 ....ALMOST FIT.... THIS PRODUCT WAS 5/16 X 3/4" ..JUST A LITTLE BIT TO TIGHT ... IT WOULD HAAVE WOORKED IF IT WAS 7/8" WIDE RATHER THAN 3/4" DO YOU HAVE A GLIDE 3/4" WIDE ? OR WHAT WOULD YOU REC ... (cont.)

The plastic wheel broke on my closet door. Do you carry a replacement?

where can I find a 70-655 hinge for a Yorktown cabinet

do you have distribuidors in mexico. I need the product Kenlin Draer Sochet Thank you

The hinge angle on my hinge is a 45 degree angle rather than a 90 degree angle like, I think the one in your picture shows, in relationship to the base plate.

looks like KENLIN CASE RUNNER except there is no wheel Product Code: 32-076

A161.1-1990 ANSI KCMA

It appears to have the name Blum on the hinge. The door mounting screws are 1 7/8 apart

This is from a kitchen drawer. The part mounted in the cabinet is 23" long and the part mounted to the drawer bottom is 19.5" long.

Plastic drawer guide

These are in Merillat cabinets that are over 34 years old. Thank you for your help.

Gang, I have bought these as an alternative to my broken Merrilat cabinet sockets as a replacement and am having two issues. First, the socket is too long and I have to cut off about 3/4" to 1" of socket to get it to accept my rail. Secondly, when I cut it, it then breaks, as shown in the right ha ... (cont.)