Viewing all customer Discussions for:

Drawer & Cabinet

Good morning, Need as least 12 to 24 clips. See attached pics

These were installed before I bought the property, and I don't know anything about them except that it was renovated in the 80s. Thanks!

Plastic locking device for my Mid Continent Cabinetry drawers.

This is from s as dresser. Trying to match it. Check order that I placed. If you think it's wrong contact me please

This drawer slider mount in the back nothing on the sides approx 23.5 inched long. From a craftmaster cabinet that is 18 yrs old. How can i replace it so i can have my drawer again.

I have 4 plastic mounts for a cabinet tray glide. These mount on the side of the tray to the side walls of cabinet. Do you have 4 of these?

I have inherited an old cabinet - all the hardware is great except one is broken. It appears to be a cup size of just slightly under 1/2 inch. Can't seem to find this this exact model - any potential alternates? Thank you!

Hi,I was wondering if you would be able to help me locate the plastic boot guide for our drawer that is pictured. The left side broke and needed a replacement for the plastic piece.Thanks in advance!Stephen

I'm looking for 3 of these.

I need to replace a few pulls for Drexel Heritage European Retreat dresser

Do you have this part that is broken on the wall, so the drawer can be put back in?

I see this handle has 2 1/2 inch centers, but what is the overall width and height of the handle?

Previous message included a typo in my email address. I am looking for a replacement for this part, which screws into the bottom of a dresser drawer and clips into the side mounted slide rails. Thank you, Cynthia

Old Merrilot back bracket on sliding drawers have finally worn out. What can I replace them with and still use the original rails (floating).

I need some of these under mount drawer slide hanging brackets. The slides are from the manufacturer Grass. But they said the hanging brackets are not from them.

Hi, I am looking to replace Grass USA Side Mount Slide Rollers. Looking for 570mm. The model number from Grass is 01225-09 (left) and 01248-09 (right). I need 4 sets. Can you make a recommendation? Thanks Tim

HAVING A PROBLEM LOCATING RIGHT REAR DOOR GLIDE . I PURCHSED SOME 32-122'S TO BIG THEN BOUGHT SOME 32-030 ....ALMOST FIT.... THIS PRODUCT WAS 5/16 X 3/4" ..JUST A LITTLE BIT TO TIGHT ... IT WOULD HAAVE WOORKED IF IT WAS 7/8" WIDE RATHER THAN 3/4" DO YOU HAVE A GLIDE 3/4" WIDE ? OR WHAT WOULD YOU REC ... (cont.)

The plastic wheel broke on my closet door. Do you carry a replacement?

where can I find a 70-655 hinge for a Yorktown cabinet

do you have distribuidors in mexico. I need the product Kenlin Draer Sochet Thank you