Viewing all customer Discussions for:

Drawer & Cabinet

we need to find these hinges to replace the old ones. 652.220.50.00

Can I use the Kenlin 32-081 or 32-082 to replace this type of under drawer sliders? They are all broken. Do they come in multi pack plus plastic stop piece?

So I ordered part # 32-031 and it was too small. I've taken pictures. part # 32-032 seems closer but I am not sure. Can you tell me what will work? I don't mind buying a few different ones to test and see.

I believe the cabinet is by merrilat and is about 30 years old. The right side snapped and the left is starting to go. There are no screws and looks like the mount attached to the cabinet has plugs???

Hi, My cabinets have Hettich 2516 5.6 hinges. One of them is broken, and I would like to order some replacements. Doesnt have to be hettich, just compatible with the existing hinges

plastic kitchen drawer glide worn on one side

Hi, Could you let me know if you sell these replacement parts? If not, any suggestions on alternatives parts that would fit our existing cabinet setup?

I understand from your page that his Ronthor part has been discontinued and you recommend a back plate replacement..... however, with my dresser, the drawers are notched in the back, and I?m not sure how to fasten. Do you have any other suggestions?

Trying to find this drawer slide rear bracket. The round part snaps into a metal clip at the rear of the cabinet.

plastic piece is 3"x 1-1/8" overall. metal drawer guide is 7/8" overall. thank you !

Hi, I need to replace 8 of these in an old kitchen. Do you have them or know what they are called so I could search for them. Any help would be appreciated.

I'm looking for black hinges that could be used as replace for the attached pictures. I don't want to have to re-drill the plate holes, and I'm struggling to find the correct length of plate.

I inherited 2 night stands with center mount slides the drawers go into the runners no problem but they don't fit very snugly and their is nothing that secures the drawer to the runner. I have a random piece that I can't figure out how it attaches or if it belongs. I have only 4 drawers to fix. Help ... (cont.)

Hello, I need to replace the drawer back plate is broken. The rails are 23" long. I have not been able to find replacement plates in the city. So I will buy extras once I find them. Thanks for your help.

I am looking to replace several old Ajax kitchen cabinet hinges that have a 3/8" inset and a 1/4" overlay in antique Bronze. The hinges are about 40 years old and have either 597 51 or 597 51 on the back side of the hinge. 3/8" overlay hinges cause the old screw holes to be exposed and will not wo ... (cont.)

It is inside cabinet behind the drawer. It's about 3in tall. I operates along the same principles as the magnetic pop-up door closer/catch. When you push the drawer in it loads it then when you push the drawer again it pops out and pushes the drawer open enough to grab it and open it, but you alread ... (cont.)

Hello - I dropped a heavy item on the drawer and bent the face frame undermount brackets of the drawer. The drawer undermount slide is 19 3/4" and the bracket that attaches to the back cabinet is 23 1/8". Do you have replacement brackets and back wall mount? Saw an answer on your website that sai ... (cont.)

The side of the stop cracked off and I'm trying to replace it .instead of screws it plug into the back wall

No marks. Measures 2.5" wide 1.75 tall and3/8 deep

I am searching for a replacement knob for my Pulaski chest. Pulaski Accent Chest 704286 I have included the other hardware used to compliment the drawer pull. Thanks in advance. Angela.