Viewing all customer Discussions for:

Drawer & Cabinet

Hi, I bought the Cluthe Drawer Guides to replace our old ones, but they are just slightly not wide enough. We have very old from the 80s drawer guides labelled Hardware Designers Inc., USA with a number on them. Photo is attached. They are sort of falling apart and the plastic is rubbing off too. T ... (cont.)

This is a bracket to hold the drawer on to the slider in a dresser. Can you find me one that fits. Thanks.

Hello. I'm wondering if you could recommend a piece that might work? I have Upload a picture of a working one and then one with the piece missing On the back of the drawer underneath

One of mine broke need replacement R;4028. 201187

Model number is 698.254.53.00. I need it for a right opening cabinet.

It looks like your part 32-351 is what I need but I'm not sure about the dimensions noted. My broken piece is 2 9/16 inches tall and 1 5/16 inches wide and about 1/2 inch deep. That's for one half of the complete hinge.

Hello, I am looking for a replacement drawer slide for an Office Depot Magellan desk I have. The measurements are 13 3/4" closed, fully extended it is almost 31". It is 1/2" deep and 1 1/2" wide. Can you guide me in the right direction? Thanks for your time. Charlie

Rockler does not gave this product and referred me to you. I am looking for a drawer side guide that screws in.

Iam looking for a Larson Storm door hinge for #34614032.122110203

Furniture Made in Mexico, no part number found

This part broke in half. It 2" in length from end to end.

I didn't see any identifying numbers or markings. I've been getting by by taping the bottom box where the rail sits. I think I'm at the end of the rope on that strategy. I'm hoping you can help.

I am looking for a replacement cabinet hardware for a Merrillat bi-fold corner cabinet. The cabinets are from 1999.

I have a desk drawer that uses this to slide drawer and keep in place. Where can I find this replacement part

Hi, can you help me figure out what hinge to buy for the following under-the-sink cabinet? ANS KCMA A161.1-200 (code H) Thank you!

Hello,The moveable part inside the bottom slide of the drawer is missing on a couple of my drawers-looking for that piece to reinsertThank you,Janice

NEED HELP IN REPLACEMENT SCHEIRICH KITCHEN CABINET HINGES.LOOKING FOR FOUR HINGES. ANY ASSISTANCE WOULD BE APPRECIATED.VINCE

Huntly Furniture -- 4 1/2" at center.

I am looking for Grass 830-53 replacement hinges for 4 cabinet doors

Do you sell slides for Thomasville 5 drawer oak bedroom chest